@Krystia. eazy yes it will work you want to chill 200ml of 98% sulfuric acid to 0° Celsius then you want to add to that a mixture of powdered ammonium nitrate 100% pure & anhydrous with powdered erythritol 120g of an & 30g of eyrthitol, I add half of the ammonium nitrate first then mix the erythritol in with the remaining ammonium nitrate and finish adding, when you're adding you do not want the temperature to rise above 20° Celsius but you want to get the temperature up to 18 degrees Celsius and keep it between 18-20 the entire time!!!! this is very important and will determine ur yield, the more of the mix you add into the acid the faster the hotter it will get, you want the mixture to stay a white color or a cream color like pancake batter but it cannot turn yellow that is a sign of decomposition of etn, if you maintain the 18-20 degrees Celsius you will have no problems this needs to be done on a stir plate and this mixture will get very thick and you need to have a stir rod to help the stir plate, you must add the mixture and slowly but in 1hour have that mixture added, if you add too much it will start gassing & this is not good, if this happens stop adding and stir vigorously, you will have to adjust the stir plate as the thickness increases, all this is done with a reaction vessel in an ice bath, also mind the reaction vessel size & the size of the magnetic stir Gizmo (the little white thing in the bottom of the reaction beaker) once it's added in & the temperature is still under 20 degrees Celsius stop the magnetic stir plate and let it sit i let it sit for about an hour stirring occasionally always maintaining the temperature not letting it get above 20° Celsius once you get the balance down your yield will start to increase what's the hour is up while stirring I crash that mixture into refrigerator cold distilled water that has some sodium bicarbonate in it, just a little or too much will make it foam over, that is filtered through three coffee filters then using copious amounts of distilled water and sodium bicarbonate neutralize the crude ETN I then dry and then mix with warm to hot methanol but you can use ethanol too when its dissolved I had a small amount of sodium bicarbonate I then pour that mixture VERY slowly into room-temperature distilled water stirring pretty vigorously that gets me the best consistency recrystallized Etn but you may find a better way or a way that you find is better than mine now hurry up and copy this cuz I'm going to erase it soon if you're not subscribed please subscribe 👍