Sciencemadness Discussion Board

Vanadium Pentoxide Catalyst

low.safety.standards - 6-4-2020 at 13:03

Hey people,

Anyone has any information on how I can make vanadium pentoxide pellets? I have the chemical as a (highly toxic) fine dust and I wanted something heavier with a large surface area.

The final objective is to make a miniaturized Wet sulfuric acid process plant.

[Edited on 6-4-2020 by low.safety.standards]

BaFuxa - 12-4-2020 at 00:21

Just place it onto a catalyst support of your choice, can be broken up tiles, concrete, pumice, scoria, glass/ quartz wool etc anything that resists high temperatures and has high surface area.

I would just soak said support in ammonium metavanadate and oxidize it with a blow torch. The V2O5 particles should be nested in the pores and not come off. Safer than a free flowing powder anyway.

2 NH4VO3 → V2O5 + 2 NH3 + H2O @ 500-550°C.

Now if I had to use V2O5 powder I would disperse it water and just immerse the catalyst support into it with a good stir for some time, I doubt it is a very effective method as far catalyst loading goes however.