Chemically Curious - 21-7-2023 at 22:41
Ok I've been trying different ratios to of SHMP source I believe it's a photographic whitener it's from an Italian photographic chemical company, SiO2
source moisture absorber packs, Al source foil blended to fine powder, even done a couple of runs with carbon and Na. best I've been able to obtain is
around 7% even tried different setups glass retort ,steel threaded pipe retort, and a small paint can with copper arm condenser retort. any help with
helping me get better yielding recipe or better route would be greatly appreciated ... pics of setups I've tried attached. the all glass retort was
the inner tube of a 300mm water cooled condenser it had a 24 /40 male end on it I heated it up a lil much and touched the water in the collector and
thermally shocked it oops.... if you have a better recipe please list the sources of chems, grades or the route went to obtain the chems to give an
idea of quality/consistency of what was used again any help is greatly appreciated cause as of now I'd been better off spending my money on as many
match books as possible to obtain what I am after
charley1957 - 22-7-2023 at 06:05
There’s a sticky thread in this forum with currently 60 pages of discussion and experimentation in phosphorus isolation. You may find what you’re
looking for there.