LOL off you go then, should take you 5 mins to knock up a circuit and connect that to a micro .
You might want to read the pen recorder manual first, and re read the GC one..... just in case
I take it your assuming two things
1 it outputs a voltage
2 the voltage output is <100mV?
Looking at your other post i can see why you think this, i can also see why you might think from the manual. But i suggest before you go jumping on
this and designing something, check the pen manual and read the specs again.
Out of interest what is your take on what is output on the back of the GC? I think you focused on the 1mV range without looking at the pen manual.
[Edited on 20-2-2018 by NEMO-Chemistry]
[Edited on 20-2-2018 by NEMO-Chemistry] |