underground
National Hazard
Posts: 692
Registered: 10-10-2013
Location: Europe
Member Is Offline
|
|
Digital pocket scale problem
I have bough a digital pocket scale like this from ebay and it can geigh up to 1000 g. In the past it was ok but no when i open it, it shows 1000.0 g. MODE does not do anything. When i
press TARE it changes to 500.0 , 300.0 , 200.0 , 100.0 , and then back to 1000.0. The strange think is that if i close it and repoen while i have
pressed the on/off button it works normally, but when i release it, it starts the same. Any thoughts ?
[Edited on 11-4-2019 by underground]
|
|
|
TheMrbunGee
Hazard to Others
Posts: 364
Registered: 13-7-2016
Location: EU
Member Is Offline
Mood: Phosphorising
|
|
Quote: Originally posted by underground  | I have bough a digital pocket scale like this from ebay and it can geigh up to 1000 g. In the past it was ok but no when i open it, it shows 1000.0 g. MODE does not do anything. When i
press TARE it changes to 500.0 , 300.0 , 200.0 , 100.0 , and then back to 1000.0. The strange think is that if i close it and repoen while i have
pressed the on/off button it works normally, but when i release it, it starts the same. Any thoughts ?
[Edited on 11-4-2019 by underground] |
Maybe try changing batteries..
|
|
|
markx
National Hazard
Posts: 645
Registered: 7-8-2003
Location: Northern kingdom
Member Is Offline
Mood: Very Jolly
|
|
Perhaps you have engaged the calibration mode? Some scales have such option available. It shows the mass of the calibration weights that one is
supposed to put on the scale when it runs through the cycle. Just a thought....
Exact science is a figment of imagination.......
|
|
|
underground
National Hazard
Posts: 692
Registered: 10-10-2013
Location: Europe
Member Is Offline
|
|
I have already done it
| Quote: Originally posted by markx | | Perhaps you have engaged the calibration mode? Some scales have such option available. It shows the mass of the calibration weights that one is
supposed to put on the scale when it runs through the cycle. Just a thought.... |
Maybe but i have not any idea how to return it to normal.
[Edited on 11-4-2019 by underground]
|
|
|
Ubya
International Hazard
Posts: 1232
Registered: 23-11-2017
Location: Rome-Italy
Member Is Offline
Mood: I'm a maddo scientisto!!!
|
|
I bet it's the calibration setting, there are only 3 buttons so try everything. To enter calibration mode on my balance I need to keep pressing on the
mode button. Try keeping pressure on the mode button, then on the tare button and then on the on/off button, one of these 3 should work. If this fails
try a combination of 2 buttons etc.
It shouldn't be hard on this cheap balances
---------------------------------------------------------------------
feel free to correct my grammar, or any mistakes i make
---------------------------------------------------------------------
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
