John paul III
Hazard to Others
Posts: 110
Registered: 28-4-2018
Member Is Offline
Mood: No Mood
|
|
Could nitration of cellulose proceed more quickly in acetone?
Since acetone dissolves nitrocellulose, It could theoritically speed up the nitration, as it would bring the less nitrated chains into solution
allowing complete nitration faster. Also I imagine the inner chains of a cellulose fiber have worse access to the nitrating agent, so the removal of
outer layers of NC would improve penetration of the reactants.
I'll give it a try, especially since my previous NC syntheses resulted in a product that leaves too much ash, unless there's additional safety
concerns over normal nitration (beside using flammable VO solvent)
|
|
|
TheMrbunGee
Hazard to Others
Posts: 364
Registered: 13-7-2016
Location: EU
Member Is Offline
Mood: Phosphorising
|
|
Not an nitrating expert, but I am pretty sure, that acetone will react with nitrating mix, probably causing runaway.
|
|
|
Herr Haber
International Hazard
Posts: 1236
Registered: 29-1-2016
Member Is Offline
Mood: No Mood
|
|
Mhh, probably not.
Low % NC doesnt dissolve that well in acetone.
Urbanski has a fantastic chapter on NC, what solvents are used in different conditions.
Speaking about conditions: From memory, an "ideal" nitrating mixture should contain around 8-12% of water at the beginning of the nitration.
That's pretty much concentrated acid that you'll need to cool a lot if you want to avoid a runaway with acetone.
First, by cooling that much you'll be slowing the reaction rate
Second, you'll make the mixture more viscous probably hindering the effect you are trying to obtain.
The spirit of adventure was upon me. Having nitric acid and copper, I had only to learn what the words 'act upon' meant. - Ira Remsen
|
|
|
rockyit98
Hazard to Others
Posts: 283
Registered: 12-4-2019
Location: The Known Universe
Member Is Offline
Mood: no mood is a good mood
|
|
why not Xylene ? after all it's called and sold as "NC Thinner" for that reason.
"A mind is a terrible thing to lose"-Meisner
|
|
|
Herr Haber
International Hazard
Posts: 1236
Registered: 29-1-2016
Member Is Offline
Mood: No Mood
|
|
Wouldnt you be better off trying another type of cellulose ?
I've never tried MCC but reports seem to indicate it doesnt burn as well as expected. It might be good for lacquer though.
If achievable I dont think your idea would really or only make the reaction much faster but maybe make it more complete resulting in higher nitrated
NC.
Humm... I think I'll read that chapter in Urbanski's book.
The spirit of adventure was upon me. Having nitric acid and copper, I had only to learn what the words 'act upon' meant. - Ira Remsen
|
|
|
Metacelsus
International Hazard
Posts: 2531
Registered: 26-12-2012
Location: Boston, MA
Member Is Offline
Mood: Double, double, toil and trouble
|
|
Xylene would also react with nitric acid.
|
|
|
NonEthicalPyrotechnics
Harmless
Posts: 12
Registered: 12-11-2019
Member Is Offline
|
|
Maybe you could try using powdered cellulose in the nitration. Lightly stir it during the entirety of the nitration.
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
