Sulaiman
International Hazard
Posts: 3558
Registered: 8-2-2015
Location: 3rd rock from the sun
Member Is Offline
|
|
Non-abrasive removal of 3A sieve residue ?
I had 500g of 3A molecular sieves wet with water and ethanol in a 1000ml rbf
and I distilled off most of the ethanol using a water bath.
The flask now has residue stuck to the inner wall near the bottom of the rbf,
a rinse with conc. HCl followed by 12 hours soaking in dilute HCl removed some of the residue,
washing with detergent made no difference.
I do not want to use abrasive methods as the rbf is new and unscratched.
How can I dissolve or dislodge (presumed) aluminosilicates without damaging the rbf - any suggestions ?
CAUTION : Hobby Chemist, not Professional or even Amateur
|
|
|
unionised
International Hazard
Posts: 5104
Registered: 1-11-2003
Location: UK
Member Is Offline
Mood: No Mood
|
|
Sodium hydroxide solution might remove the residue.
Or you might just consider this flask to have permanent, not very good, anti-bumping granules in it.
[Edited on 26-7-20 by unionised]
|
|
|
Sulaiman
International Hazard
Posts: 3558
Registered: 8-2-2015
Location: 3rd rock from the sun
Member Is Offline
|
|
I will leave hot KOH (I have no NaOH) as a last resort as it will probably eat some of the rbf along with the aluminosilicate(s).
___________________________________________________________
D'oh !
I feel dumb now ... the residue came off easily when I just used water, dtergent and a bottle brush.
[Edited on 26-7-2020 by Sulaiman]
CAUTION : Hobby Chemist, not Professional or even Amateur
|
|
|
draculic acid69
International Hazard
Posts: 1371
Registered: 2-8-2018
Member Is Offline
|
|
Maybe just a room temperature soak of hydroxide rather than a hot one would be better.i wouldn't leave hydroxide as a last resort it seems to be a
good option. hot hydroxide can be a last resort but it's definitely worth trying at room temperature
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
