yobbo II
National Hazard
Posts: 709
Registered: 28-3-2016
Member Is Offline
Mood: No Mood
|
|
EMP device for pesky drones
Hi,
Has anyone any knowledge or info. on a EMP generator that could be used to disable drones. (swat them from the sky).
I don't wont anything too exotic using explosives (god forbid!).
I am thinking of a great big HV capacator + coil + aerial (directional would be good).
I don't know anything about the subject.
Cheers,
Yob
|
|
|
Twospoons
International Hazard
Posts: 1280
Registered: 26-7-2004
Location: Middle Earth
Member Is Offline
Mood: A trace of hope...
|
|
I thought about this as a way to silence my neighbor's stereo late at night.
I would be inclined to try an elliptic horn antenna (wide bandwidth, good directivity) with a spark gap at the feed point. There's a good chance you
could cause the microcontroller on the drone to reset or lock up.
Helicopter: "helico" -> spiral, "pter" -> with wings
|
|
|
wg48temp9
National Hazard
Posts: 761
Registered: 30-12-2018
Location: not so United Kingdom
Member Is Offline
|
|
You may be able to do it with a bigish parabolic dish with the magnetron and power supply from a microwave oven, depending on how close the drone is
and how much you increase the pulse power of the magnetron or with an array magnetrons.
PS: from my leaky experiments with magnetrons they cause buzzing on near by (about 25m) portable radios and that was without a dish and through a
wall of a garage. The oven power supplies pulse the magnetron at about 1:5 so peak power is several kilowatts. That could be increases to 10kW pk or
more depending the emission of the filament of the magnetron.
Of cause this is illegal in most countries and potentially dangerous to people so this is just for theory.
[Edited on 10/5/2020 by wg48temp9]
PSS: The small size and ground planes of modern PCBs make them very resistant to EMI but the antenna of the radio is the weak point so its probably
very easy to saturate the receiver front end or to even damage it compared to resetting the microcontroller. It could also interfere with wifi or
damage wifi receivers as they operate in the same frequency band as microwave ovens.
[Edited on 10/5/2020 by wg48temp9]
I am wg48 but not on my usual pc hence the temp handle.
Thank goodness for Fleming and the fungi.
Old codger' lives matters, wear a mask and help save them.
Be aware of demagoguery, keep your frontal lobes fully engaged.
I don't know who invented mRNA vaccines but they should get a fancy medal and I hope they made a shed load of money from it.
|
|
|
unionised
International Hazard
Posts: 5102
Registered: 1-11-2003
Location: UK
Member Is Offline
Mood: No Mood
|
|
This has more style...
https://www.bbc.co.uk/news/av/world-europe-35750816
|
|
|
wg48temp9
National Hazard
Posts: 761
Registered: 30-12-2018
Location: not so United Kingdom
Member Is Offline
|
|
Yes much more style and no collateral damage to people or wifi and probably legal if its above your property.
I am wg48 but not on my usual pc hence the temp handle.
Thank goodness for Fleming and the fungi.
Old codger' lives matters, wear a mask and help save them.
Be aware of demagoguery, keep your frontal lobes fully engaged.
I don't know who invented mRNA vaccines but they should get a fancy medal and I hope they made a shed load of money from it.
|
|
|
Twospoons
International Hazard
Posts: 1280
Registered: 26-7-2004
Location: Middle Earth
Member Is Offline
Mood: A trace of hope...
|
|
I'd be worried about the birds being injured by the prop blades. Seems rather unethical to me.
Maybe its time to build a drone that attacks other drones. All you'd need to do is drop some string into the victim's props.
Helicopter: "helico" -> spiral, "pter" -> with wings
|
|
|
yobbo II
National Hazard
Posts: 709
Registered: 28-3-2016
Member Is Offline
Mood: No Mood
|
|
Unfortunately I don't have any eagles.
Yob
|
|
|
MadHatter
International Hazard
Posts: 1332
Registered: 9-7-2004
Location: Maine
Member Is Offline
Mood: Enjoying retirement
|
|
Drones
No birds ? No problem. 12 GAUGE ! 
From opening of NCIS New Orleans - It goes a BOOM ! BOOM ! BOOM ! MUHAHAHAHAHAHAHA !
|
|
|
yobbo II
National Hazard
Posts: 709
Registered: 28-3-2016
Member Is Offline
Mood: No Mood
|
|
Believe it or not! I did actually think of the 12 gauge. I believe it is illegal to shoot down a drown (unless of course by accident).
There is a guy selling a device out there that shoots out a net.
https://thenetgunstore.com/blogs/blog/net-guns-for-drone-def...
You could probably catch the eagle too
I have attached a device that emits EMP. It seems doable to build untill you come at the part what needs a 'fast' spark gap. That's a spark gap in a
chamber with H or N gas under pressure. SF6 will do to with less pressure. Not so simple.
It used a fairly ordinary spark gas exciting a tesla coil followed by a pulse shaping line (simple) enough to do if you just use the dimentions given.
Then the annoying bit is the 'fast' spark gap and an aerial.
The math is way beyond me but he gives dimensions etc.
The whole thing is put into oil.
How would you get around the 'fast' spark gap bit?
I desire a drone swatter. Will trade 12 gauge........
The file is too big.
Google Thesis-2008-Sarkar
https://repository.lboro.ac.uk/articles/thesis/A_compact_and...
|
|
|
Sulaiman
International Hazard
Posts: 3555
Registered: 8-2-2015
Location: 3rd rock from the sun
Member Is Offline
|
|
I'd consider a directional antenna and a few watts at 2.4GHz to overload the receiver front end
CAUTION : Hobby Chemist, not Professional or even Amateur
|
|
|
unionised
International Hazard
Posts: 5102
Registered: 1-11-2003
Location: UK
Member Is Offline
Mood: No Mood
|
|
At least some of the drones are autonomous.
You could try blocking GPS location data.
|
|
|
Heavy Walter
Hazard to Others
Posts: 127
Registered: 17-12-2015
Location: Argentina
Member Is Offline
Mood: No Mood
|
|
Mr Bob Iannini, in his book Electronic Gadgets for the Evil Genious show an EMP gun.
|
|
|
wg48temp9
National Hazard
Posts: 761
Registered: 30-12-2018
Location: not so United Kingdom
Member Is Offline
|
|
Thanks for the interesting thesis. I have never seen the details of a Tesla coil powered EMP device before. Considering its generating about half a
million volts its a compact Tesla coil thanks to the oil insulation and as you stated most of the construction is doable DIY. The spark gap of the
Tesla coil perhaps could be ambient air or hydrogen as it does not have to be as fast as the pulse output spark gap.
I wounder if using the 0.5MV in a particle accelerator (an evacuated long tube containing an anode and cathode) what experiments could be done.
PS: Apparently from wiki, Lichtenberg figures created within solid insulating materials uses 25MeV electrons so I guess only 0.5MV will not be
sufficient.
[Edited on 10/8/2020 by wg48temp9]
I am wg48 but not on my usual pc hence the temp handle.
Thank goodness for Fleming and the fungi.
Old codger' lives matters, wear a mask and help save them.
Be aware of demagoguery, keep your frontal lobes fully engaged.
I don't know who invented mRNA vaccines but they should get a fancy medal and I hope they made a shed load of money from it.
|
|
|
Sulaiman
International Hazard
Posts: 3555
Registered: 8-2-2015
Location: 3rd rock from the sun
Member Is Offline
|
|
Have a look on YT for 'herf gun'
CAUTION : Hobby Chemist, not Professional or even Amateur
|
|
|
Twospoons
International Hazard
Posts: 1280
Registered: 26-7-2004
Location: Middle Earth
Member Is Offline
Mood: A trace of hope...
|
|
https://www.up.ac.za/media/shared/Legacy/sitefiles/file/44/1...
I still think that the elliptical horn, with a simple air spark gap at the feed end, operating at 25kV or so, would be the simplest thing to try.
You're just trying to create broadband noise of high field strength - no need to worry about frequency, or impedance matching or efficiency or
high-speed hydrogen spark gaps.
The antenna is just two pieces of metal plate - aluminium is easiest to work with - with a former (plywood?)
25kV is easy too - plenty of examples on the net of devices built from a couple of transistors and an old TV line output transformer (search terms:
Royer oscillator, or Mazilli driver)
For comparison a simple EMC susceptibility test we use in electronics is the chattering relay test: a relay is connected so that it interrupts its own
coil current, resulting in the thing buzzing continuously, with arcing on the switch contacts. This produces a lot of electrical noise, and is a good
thumb-suck test - if this will knock over your electronics you have a problem and need to do a bit more design work!
You really dont need anything fancy to create EMI.
Helicopter: "helico" -> spiral, "pter" -> with wings
|
|
|
sodium_stearate
Hazard to Others
Posts: 255
Registered: 22-4-2011
Location: guard duty at the checkpoint
Member Is Offline
Mood: No mask.
|
|
buzzing relay
Twospoons:
Yes, I have observed that very phenomenon you mention!
In a digital logic circuit which has some relay outputs,
I have seen this many times. The tiny spark generated
at the contacts just so happens to be close to the coil.
The coil then acts as a crude antenna. The result is a bunch of
hash and noise which can get back on to the Vcc and GND bus,
and wreak all sorts of havoc to nearby logic.
Usually a little filtering will mitigate this enough to
allow the logic to resume working correctly, unaffected
by the relay noise.
But your observation that this can be used as a simple
crude test is spot on! 
"Opportunity is missed by most people
because it is dressed in overalls and it
looks like work" T.A. Edison
|
|
|
yobbo II
National Hazard
Posts: 709
Registered: 28-3-2016
Member Is Offline
Mood: No Mood
|
|
There is a jammer here:
https://aliexpress.ru/item/4000968563014.html?spm=a2g0o.deta...
It would be an easy solution if it worked. You need a yagi with it
|
|
|
yobbo II
National Hazard
Posts: 709
Registered: 28-3-2016
Member Is Offline
Mood: No Mood
|
|
Youtube vid here https://www.youtube.com/watch?v=oJOSfnETiG4
looks a bit like the device in the theses
there is an interesting WIFI 'stealing' device here
https://www.youtube.com/watch?v=GWq6L94ImX8
Together
[Edited on 11-10-2020 by yobbo II]
|
|
|
yobbo II
National Hazard
Posts: 709
Registered: 28-3-2016
Member Is Offline
Mood: No Mood
|
|
https://www.youtube.com/watch?v=rAzzmdDqT6Q
|
|
|
njl
National Hazard
Posts: 609
Registered: 26-11-2019
Location: under the sycamore tree
Member Is Offline
Mood: ambivalent
|
|
I wonder if those deauthors that are so common now could interfere with a wifi controlled drone? I think that as long as they're using the right kind
of security protocol you should be able to at least detect the signal.
|
|
|
zed
International Hazard
Posts: 2277
Registered: 6-9-2008
Location: Great State of Jefferson, City of Portland
Member Is Offline
Mood: Semi-repentant Sith Lord
|
|
Hnuh? A drone over your property? No problem. Kill it.
I imagine a shotgun would do that nicely.
Not legal to fire a shot-gun within the limits of most cities.
But, I can't imagine a paintball gun would be illegal.
Can you jam a drone frequency? Yes!
Among them, radio frequency (RF) jamming, or jammers, can be used to disrupt the RF signal of the drone, causing it to fail. Generally, this
RF-Jamming is either at 2.4Ghz or 5.8Ghz, which are “non-assigned” public frequencies. ... Jammers are effective against drones over several
kilometres distance.
I did not write this. Just a quick internet look-up.
[Edited on 20-10-2020 by zed]
|
|
|
pneumatician
Hazard to Others
Posts: 409
Registered: 27-5-2013
Location: Magonia
Member Is Offline
Mood: ■■■■■■■■■■ INRI ■■■■■■■■■■ ** Igne Natura Renovatur Integra **
|
|
Ask the Iran how to capture a drone
well, police use some shit in aeroports and co.
Some high power laser?
or use all this shit debunkers use to "explain" the dissaperances in Bermuda triangle work 100% sure ha ha ha :-DDD
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
