Sciencemadness Discussion Board
Not logged in [Login - Register]
Go To Bottom

Printable Version  
Author: Subject: Microbiology/Tissue culture incubator
magnus454
Hazard to Self
**




Posts: 57
Registered: 28-2-2007
Location: Clear Lake City, TX
Member Is Offline

Mood: No Mood

[*] posted on 22-9-2011 at 14:23
Microbiology/Tissue culture incubator


I may have found something so I can build a microbiological incubator for my samples, petri dishes, and such. I found these natural terrarium (by zoomed), the are glass and plastic with a front entry door. the top is screen, so I'll replace it with a sheet of Lexan or glass on top glued in. I can add reptile terrarium heating rope to the very bottom held down with self adhesive pads, and a sheet of insulation on the underside of the bottom to reflect upward. I can put a small fan in the unit to move the air around to keep the heat even, and some shelving with holes in it for good air flow. an external thermostat to run the heater. I have an idea to upgrade the unit to handle CO2 atmospheres for advanced tissue culture, figure I can use a premium air stone in the front bottom, and a few small vent holes in the top back to distribute the CO2 injection. I just need to get a regulator, and the CO2 tank, and a meter that will read concentration in % for controlling the atmosphere inside. I'll take the light hood off.

Entry2_100_MainPicture.jpg - 47kB




History is repeating itself.
View user's profile Visit user's homepage View All Posts By User
Steve_hi
Hazard to Others
***




Posts: 196
Registered: 4-12-2010
Member Is Offline

Mood: No Mood

[*] posted on 23-9-2011 at 03:59


Nice idea I hope it works out well for you.

[Edited on 23-9-2011 by Steve_hi]
View user's profile View All Posts By User

  Go To Top