Cesium Fluoride
Harmless
Posts: 48
Registered: 26-1-2005
Member Is Offline
Mood: Cupric
|
|
Oxidatively stable solvent
Hi all,
It's been a while since I've posted here, but I have a question I think you all will be good at answering. I'm doing some electrochemistry and I need
to run a cell in the presence of a peroxide salt under high potentials. I am looking for ideas of solvents that display extreme stability under
oxidative conditions.
Solvents I have tested that have decomposed include DMSO, alkyl carbonates, and ethylene-glyol-based ethers (DME and other glymes). My only untested
idea thus far is siloxanes as I know pump oils have good oxidative stability. Any other suggestions would be much appreciated.
[Edited on 14-3-2012 by Cesium Fluoride]
[Edited on 14-3-2012 by Cesium Fluoride]
|
|
|
497
National Hazard
Posts: 778
Registered: 6-10-2007
Member Is Offline
Mood: HSbF6
|
|
Fluorocarbons?
|
|
|
Cesium Fluoride
Harmless
Posts: 48
Registered: 26-1-2005
Member Is Offline
Mood: Cupric
|
|
Sulfones?
|
|
|
unionised
International Hazard
Posts: 5102
Registered: 1-11-2003
Location: UK
Member Is Offline
Mood: No Mood
|
|
IIRC acetic acid and acetonitrile are quite good.
|
|
|
BromicAcid
International Hazard
Posts: 3227
Registered: 13-7-2003
Location: Wisconsin
Member Is Offline
Mood: Rock n' Roll
|
|
Carbon tet, AFAIK Mn2O7 and Cl2O7 solutions are stable (as stable as they ever are).
|
|
|
PHILOU Zrealone
International Hazard
Posts: 2893
Registered: 20-5-2002
Location: Brussel
Member Is Offline
Mood: Bis-diazo-dinitro-hydroquinonic
|
|
CO2?
N2O5?
PH Z (PHILOU Zrealone)
"Physic is all what never works; Chemistry is all what stinks and explodes!"-"Life that deadly disease, sexually transmitted."(W.Allen)
|
|
|
AndersHoveland
Hazard to Other Members, due to repeated speculation and posting of untested highly dangerous procedures!
Posts: 1986
Registered: 2-3-2011
Member Is Offline
Mood: No Mood
|
|
Water is the most obvious choice, but apparently water is not suitabe for your reaction for some reason, otherwise you would not have asked this
question.
There are not many solvents that are both liquid at room temperature, can dissolve ions, and can withstand oxidizing radicals.
Pressurised liquid CO2 might be appropriate. Liquid SO2 is easier to liquify and more polar, but not sure if it can dissolve salts.
A more expensive and less commonly available solvent is perfluorooctane sulfonate. Not sure if it could withstand oxidative radicals.
|
|
|
Dr.Bob
International Hazard
Posts: 2658
Registered: 26-1-2011
Location: USA - NC
Member Is Offline
Mood: No Mood
|
|
NMP might survive, not sure. It is more stable than DMF or DMSO (which will oxidize readily). Diphenyl ether mixtures (DowTherm A) might also work.
But they are all oxidizable, and may react.
Ionic liquids might also be good, not sure if they would work in a electrochemical cell or not.
|
|
|
Cesium Fluoride
Harmless
Posts: 48
Registered: 26-1-2005
Member Is Offline
Mood: Cupric
|
|
NMP is a good suggestion, thank you.
Very nonpolar things like fluorocarbons or CCl4 are not ideal since it will be hard to find a salt greasy enough for them to dissolve.
|
|
|
AndersHoveland
Hazard to Other Members, due to repeated speculation and posting of untested highly dangerous procedures!
Posts: 1986
Registered: 2-3-2011
Member Is Offline
Mood: No Mood
|
|
Nitrosyl perchlorate, NOClO4, might be considered. Although it is an explosive, it is at least much more stable than N2O5, Cl2O7, or Mn2O7.
http://www.sciencemadness.org/talk/viewthread.php?tid=196
http://web.mit.edu/semenko/Public/Military%20Manuals/RogueSc...
Carbon tetrachloride is not going to be able to dissolve polar or ionic compounds. And it may likely not be completely resistant to oxygen radicals.
| Quote: |
HClO4 is insoluble in CCl4, and gives upon shaking, a green emulsion, which discolors brown after several minutes welling up under formation of HCl
and COCl2 (Vorländer, v. Schilling, Lieb. Ann. 310 [1900] 374). Preparation of solutions of Cl2O7 in CCl4 described in: F. Meyer, Keszler (Ber.
54, [1921] 569).
|
[Edited on 27-3-2012 by AndersHoveland]
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
