denatured
Hazard to Others
Posts: 151
Registered: 7-8-2004
Location: -
Member Is Offline
Mood: HCl 50%?
|
|
Anyone Knows Analytical Chemistry?
Hello
This question is a bet between us and our chemistry professor if any of us could answer it before the next lecture she/he will get 40 out of 100.
The question is : Calculate the pH value for HCl M = 10power -8 ( how do you write superscript anyway?)
When i try to solve it , i get a pH of 8!!! which is WRONG
|
|
|
bereal511
Hazard to Others
Posts: 162
Registered: 9-8-2005
Location: Madison, WI
Member Is Offline
Mood: No Mood
|
|
That's really strange...I always thought -log(pH would still work in this situation.
Perhaps you can use the K<sub>a of HCl and find your pH from there? It would probably end up being 8 anyway. so I'm not quite sure.
[Edited on 10-10-2005 by bereal511]
As an adolescent I aspired to lasting fame, I craved factual certainty, and I thirsted for a meaningful vision of human life -- so I became a
scientist. This is like becoming an archbishop so you can meet girls.
-- Matt Cartmill
|
|
|
solo
International Hazard
Posts: 3967
Registered: 9-12-2002
Location: Estados Unidos de La Republica Mexicana
Member Is Offline
Mood: ....getting old and drowning in a sea of knowledge
|
|
Ph2....but best to read this.....solo
http://www.purchon.com/chemistry/ph.htm
It's better to die on your feet, than live on your knees....Emiliano Zapata.
|
|
|
vulture
Forum Gatekeeper
Posts: 3330
Registered: 25-5-2002
Location: France
Member Is Offline
Mood: No Mood
|
|
Your pH formula is an approximation which assumes that the concentration of H+ exceeds 10^-7M (common dissociation of water in fact).
With lower concentrations you need to use the quadratic equation, which can be derived by writing the mass and charge balance and solving that for H+.
One shouldn't accept or resort to the mutilation of science to appease the mentally impaired.
|
|
|
Magpie
lab constructor
Posts: 5939
Registered: 1-11-2003
Location: USA
Member Is Offline
Mood: Chemistry: the subtle science.
|
|
I agree with solo and the vulture but will give a few more hints.
1. 10^-8 molar contribution of H+ from the HCl is pretty minor as pure water contributes 10^-7 molar H+. So you know it will be very, very, slightly
acid, i.e., very, very slightly below pH 7.
2. H+ from HCl is 10^-8 as it is a strong acid and dissociates completely.
3. Kw = 10^-14 = [H+][OH-].
4. HOH -> equal parts H+ and OH- on disocciation.
Solve relations simultaneously. And as the vulture has stated a quadratic equation will be involved.
The single most important condition for a successful synthesis is good mixing - Nicodem
|
|
|
unionised
International Hazard
Posts: 5102
Registered: 1-11-2003
Location: UK
Member Is Offline
Mood: No Mood
|
|
I am an analytical chemist, or at least that's what I'm paid for so I hope I know some analytical chemistry. I don't think I would ever
have to do that calculation. It's a totally impractical matter, who would want to know the pH of M/10^8 HCl?
Not least, when you expose the solution to air it will pick up CO2 and drift to about pH5
I can't help wondering if you should share the 40% with the people who posted before me.
|
|
|
countrychemist
Harmless
Posts: 5
Registered: 28-9-2005
Location: Russellville, Arkansas
Member Is Offline
Mood: No Mood
|
|
I'm with vulture! My analytical professor tried to pull that on us last year. You must take into effect that the water dissociation constant
plays a huge role here.
2H2O <----> H3O+ + OH-
the total Kw is 10^-14. The concentration of H3O+ is 10^-7. This is larger than the H+ concentration in your HCl so it must be considered. What is
the pH of H2O? -log[10^-7] = 6
(10^-7)+(10^-8) = 10^-6
-log[10^-6] = pH 5.96
|
|
|
Magpie
lab constructor
Posts: 5939
Registered: 1-11-2003
Location: USA
Member Is Offline
Mood: Chemistry: the subtle science.
|
|
Of course you are right unionized but one could say the same thing for water. We must assume that this is an academic, not a practical question.
Countrychemist:
1. pH of pure H2O = -log [H+] = -(-7) = 7, not 6.
2. Last two equations are not only irrelvant but mathematically incorrect.
The single most important condition for a successful synthesis is good mixing - Nicodem
|
|
|
Phel
Hazard to Self
Posts: 72
Registered: 20-11-2004
Location: Scandium
Member Is Offline
Mood: viscous creep
|
|
In case someone's still stuck, the quadratic equation should look like this:
([H<sup>+</sup>])<sup>2</sup> - C<sub>acid</sub> [H<sup>+</sup>] - K<sub>w</sub> = 0
Where [H<sup>+</sup>] is the total contribution of H<sup>+</sup> from both water and HCl.
|
|
|
denatured
Hazard to Others
Posts: 151
Registered: 7-8-2004
Location: -
Member Is Offline
Mood: HCl 50%?
|
|
Thanks to all of you
Sadly i am still stuck with this math things.
I don't get vulture , if H+ exceeds then thats a good thing right? as ionized H increases the acidity increases.
In HCl case when we calculate the pH we don't count its ionization constant as it is compeletly ionized so the H+ concentration will be its molar
concentration... and we can calculate its pH through the negative logarithm... i don't why we should consider H2O ionization constant? why we use
that horrible thing called quadratic equation?.
Phel : lets say that we are using your equation ... you are saying that H+ is ........ so it will be 10^-7*10^-8?.
Unionized : as Magpie said thats just an academic sort of question don't get angry ... and they deserve to have share in the 40% if i shall get
it.
|
|
|
Quibbler
Hazard to Self
Posts: 65
Registered: 15-7-2005
Location: Trinidad and Tobago
Member Is Offline
Mood: Deflagrated
|
|
I've tried to resist adding to this academic debate. But here goes
adding 10-8 HCl (if nothing happened to the Kw equilibrium) woud give a pH of 6.9 but at such low concentrations water will act as a buffer and I
suspect the pH will remain as near to 7 as makes no difference. Of course (as has been mentioned) test some distilled water and you will find the pH
is 5.5.
|
|
|
Quibbler
Hazard to Self
Posts: 65
Registered: 15-7-2005
Location: Trinidad and Tobago
Member Is Offline
Mood: Deflagrated
|
|
Oh no I've forgot how to use logs.
log (10^-7+10^-8) = 7 - log(1.1)
or approx 7 - (0.1/2.3) = 6.96, but the pH will be even closer to 7 than this.
|
|
|
Magpie
lab constructor
Posts: 5939
Registered: 1-11-2003
Location: USA
Member Is Offline
Mood: Chemistry: the subtle science.
|
|
I really want to get my share of these 40 points, so let's just do the math:
1. Kw = 10^-14 = [OH-][H+] eqn 1
2. pH = -log [H+] eqn 2
HOH -> OH- + H+
3. Let x = [H+] from water
4. But [OH-] also = x
4. [H+] from HCl = 10^-8
5. Using eqn 1: (x+10^-8)(x) = 10^-14
This is the quadratic equation.
Solving gives x = 0.95125x10^10-7, -1.05125x10^-7.
Adding HCl's 10^-8 contribution gives [H+] = 1.05125x10^-7, -0.95125x10^-7
The second root is clearly extraneous, so [H+] = 1.05125x10^-7. pH then = -log [H+] = 7-0.0217 = 6.9783.
I hope I have not made any math errors. 
The single most important condition for a successful synthesis is good mixing - Nicodem
|
|
|
Quibbler
Hazard to Self
Posts: 65
Registered: 15-7-2005
Location: Trinidad and Tobago
Member Is Offline
Mood: Deflagrated
|
|
If you want to make approximations you can dispense with the quadratic
[H+][OH-] = 10^-14 (before)
[10^-8 + 10^-7 - d][10^-7 - d] = 10^-14 (after acid addition)
ignoring small terms
(2d).10^-7 = 10^-15
so d = 5x10^-9
[H+]= 10^-7 + 10^-8 - 5x10^-9
so pH=6.9788
(ok a little error in the 4th d.p.)
|
|
|
Magpie
lab constructor
Posts: 5939
Registered: 1-11-2003
Location: USA
Member Is Offline
Mood: Chemistry: the subtle science.
|
|
Yes Quibbler your method is better. BTW I may have an error in the 4th decimal place also.
(How can you do such detailed work in the Caribbean? I would want to be out sailing or skin diving.  )
The single most important condition for a successful synthesis is good mixing - Nicodem
|
|
|
denatured
Hazard to Others
Posts: 151
Registered: 7-8-2004
Location: -
Member Is Offline
Mood: HCl 50%?
|
|
I almost got it ... because that is a very low concentration we consider H+ from water ... but what is d in the last equation? and why we subtract
it from the product of H+ from water and acid?
All i want is to understand...
|
|
|
Borek
Unregistered
Posts: N/A
Registered: N/A
Member Is Offline
|
|
Calculation of pH of strong acid.
|
|
|
Quibbler
Hazard to Self
Posts: 65
Registered: 15-7-2005
Location: Trinidad and Tobago
Member Is Offline
Mood: Deflagrated
|
|
Well pH is really -log(activity H+).
activity H+ = conc x activity coefficient
at a conc of 1M (HCl) activity coeff. = 0.811 so pH=-log(1x0.881) = 0.091 (not zero). At lower conc the activity coeff. can be calculated using the
Debye-Huckel limiting law.
pH=-log[H+]+0.509x[H+]^½
so [H+] = 0.01 pH=2.051
[H+] = 0.001 pH=3.016
|
|
|
denatured
Hazard to Others
Posts: 151
Registered: 7-8-2004
Location: -
Member Is Offline
Mood: HCl 50%?
|
|
THANKS TO EVERYONE HERE!
I showed him the answer and it was right but the problem that he wants the answer in another method (which he will discuss in the next lecture) so he
is not giving me my 40% .........
Though i am not getting the 40% , he told me that he will help me in the oral exam...thats GREAT...
Thanks again
|
|
|
mick
Hazard to Others
Posts: 338
Registered: 3-10-2003
Member Is Offline
Mood: No Mood
|
|
water can act as an acid or base under anhydrous conditions.
mick
|
|
|
unionised
International Hazard
Posts: 5102
Registered: 1-11-2003
Location: UK
Member Is Offline
Mood: No Mood
|
|
Under anhydrous conditions water isn't there and can't act as anything.
Just out of idle curiosity, did you think that your statment was on-topic?
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
