Sciencemadness Discussion Board
Not logged in [Login ]
Go To Bottom

Printable Version  
Author: Subject: bubbling a gas through a solution
Broken Gears
Hazard to Self
**




Posts: 96
Registered: 7-8-2005
Location: Northern Europe
Member Is Offline

Mood: No Mood

[*] posted on 8-9-2006 at 05:36
bubbling a gas through a solution


First of all I would just like to say that this is a great site. Lots of priceless info. Even though most of it is far too advanced for a little newbie like me.

I have a some experiments that requires bubbling a gas through a solution. Here are some of em:
Cl2 + ethanol --> chloral hydrate
Cl2 + toluene --> benzyl chloride
N2O + sodium amide --> Sodium azide

But my question is, what is the average rate of bubbles? A bubble pr. sec? It will be a waste just to burst away with the gas, right?
Are there in general a great loss of gas?
View user's profile View All Posts By User
Nerro
National Hazard
****




Posts: 596
Registered: 29-9-2004
Location: Netherlands
Member Is Offline

Mood: Whatever...

[*] posted on 8-9-2006 at 06:12


Bubbking through something like glasswool sometimes helps to keep te bubbles small and dispersed.



#261501 +(11351)- [X]

the \"bishop\" came to our church today
he was a fucken impostor
never once moved diagonally

courtesy of bash
View user's profile View All Posts By User
vulture
Forum Gatekeeper
*****




Posts: 3330
Registered: 25-5-2002
Location: France
Member Is Offline

Mood: No Mood

[*] posted on 8-9-2006 at 10:31


Nothing stops you from recycling the gas.



One shouldn't accept or resort to the mutilation of science to appease the mentally impaired.
View user's profile View All Posts By User
evil_lurker
National Hazard
****




Posts: 767
Registered: 12-3-2005
Location: United States of Elbonia
Member Is Offline

Mood: On the wagon again.

[*] posted on 8-9-2006 at 12:39


Call up the good folks at united glass tech and have them custom make you a glass inlet adapter with a fritted fitting on the end.

Last I checked they could make one for around $45.
View user's profile View All Posts By User
Broken Gears
Hazard to Self
**




Posts: 96
Registered: 7-8-2005
Location: Northern Europe
Member Is Offline

Mood: No Mood

[*] posted on 9-9-2006 at 01:01


Quote:
Originally posted by evil_lurker
Call up the good folks at united glass tech and have them custom make you a glass inlet adapter with a fritted fitting on the end.

Last I checked they could make one for around $45.


Could you by any chance show me a picture of one? Maybe even the whole setup for bubbling gas.
View user's profile View All Posts By User

  Go To Top