RegularOldGuy
Harmless
Posts: 7
Registered: 11-9-2016
Member Is Offline
Mood: No Mood
|
|
Potassium bisulfate
Hello everyone,
I have a large clump of potassium bisulfate left over from making some nitric acid (sulfuric acid + potassium nitrate), the byproduct from is supposed
to be potassium bisulfate. I would like to use this in preparation of some pyruvic acid and was wondering, how can I clean things up by neutralizing
any sulfuric acid that might be remaining while keeping the potassium bisulfate intact? Right now its a rock hard lump in the bottom of a beaker so I
will at minimum need to redissolve it to get it out.
Thanks for any assistance!
|
|
|
Texium
|
Thread Moved
28-9-2016 at 18:46 |
Meltonium
Hazard to Self
Posts: 97
Registered: 23-9-2016
Location: Home in pajamas
Member Is Offline
Mood: Fluorinated
|
|
Just washing the salt with cold water is probably your best bet to get the remaining acid out.
|
|
|
vmelkon
National Hazard
Posts: 669
Registered: 25-11-2011
Location: Canada
Member Is Offline
Mood: autoerotic asphyxiation
|
|
1. Neutralize the acid by adding K2CO3.
or
2. Dissolve and then recrystallize and wash the crystals
Signature ==== Is this my youtube page? https://www.youtube.com/watch?v=tA5PYtul5aU
We must attach the electrodes of knowledge to the nipples of ignorance and give a few good jolts.
Yes my evolutionary friends. We are all homos here. |
|
|
unionised
International Hazard
Posts: 5102
Registered: 1-11-2003
Location: UK
Member Is Offline
Mood: No Mood
|
|
If it's a rock hard lump there probably isn't much excess acid there.
Recrystallisation from water will get rid of practically all the excess acid. Neutralising it with K2CO3 would destroy the bisulphate.
However treatment with K2SO4 would, in principle, convert the excess sulphuric acid to the desired product
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
