Germanys_Finest
Harmless
Posts: 4
Registered: 14-11-2006
Member Is Offline
Mood: No Mood
|
|
VP racing fuel
I was reorganizing my garage and found 5 x 15 gallon drums of VP racing fuel. It says it contains MTBE and tetraethyl lead on the labels. These were
here when I purchased the place and have no idea what to do with this stuff besides take it down to hazardous waste disposal, hate to waste chems.
With the price of gas being so high it would be great if I could use this in place of gas.
[Edited on 18-11-2006 by Germanys_Finest]
I just found an MSDS for this (U 4 racing fuel) it contains:
Benzene 10%
Toluene 10%
Ethylbenzene 10%
Styrene 10%
1,3-Butadiene 5%
Isoprene 10%
n-Hexane 2%
Pentane/Pentadiene 10%
Cyclopentadiene 10%
Lead 10%
That leaves the MTBE concentration being 3%
[Edited on 18-11-2006 by Germanys_Finest]
|
|
|
leu
Hazard to Others
Posts: 368
Registered: 13-10-2005
Member Is Offline
Mood: No Mood
|
|
You can use it as fuel for gasoline engines that don't have catalytic converters 
Chemistry is our Covalent Bond
|
|
|
Germanys_Finest
Harmless
Posts: 4
Registered: 14-11-2006
Member Is Offline
Mood: No Mood
|
|
Now I need to find out how to remove my catalytic converter. This stuff won't be going to waste.
|
|
|
Mr. Wizard
International Hazard
Posts: 1042
Registered: 30-3-2003
Member Is Offline
Mood: No Mood
|
|
It's not that simple. The Pb in the fuel will contaminate the exhaust system and even ruin the converter if hooked up later. You may have computerized
fuel controls on your engine that won't 'understand' what is happening with the fuel mixture. Sell the fuel and buy some regular gasoline fuel with
the money. Check out a local race track or put an ad in the newspaper. Don't ruin your engine.
|
|
|
AllanD
Harmless
Posts: 23
Registered: 16-7-2006
Member Is Offline
Mood: No Mood
|
|
I wouldn't lose sleep over it contaminating the exhaust system,
however on any modern engine (post 1979) the metallic lead will contaminate the Exhaust Gas Oxygen sensor.
Though I must add that oxygen sensors can also be cleaned
by the rather simple method of heating them with a propane flame until they glow and holding them at that temp for 5min or so.
you can usually get away with 45min to an hour of function from
an exhaust gas oxygen sensor before leaded fuel creates any detectable issues.
List the fuel on ebay "local pickup only" someone will buy it.
AllanD
|
|
|
not_important
International Hazard
Posts: 3873
Registered: 21-7-2006
Member Is Offline
Mood: No Mood
|
|
I suspect that the best bet is to sell it, as already said. You could scrub the tetraethyl lead out, but that's a lot of work and I'm not sure you'd
have a fuel that's a good balance for a standard auttomotive engine.
|
|
|
baconaut
Harmless
Posts: 8
Registered: 26-10-2006
Member Is Offline
Mood: No Mood
|
|
If you live somewhere in northern california I'd like to have some of that. I have a car that runs best on leaded fuel and I'd like to see what it
could do.
|
|
|
Fleaker
International Hazard
Posts: 1252
Registered: 19-6-2005
Member Is Offline
Mood: nucleophilic
|
|
I'll buy it all.
Neither flask nor beaker.
"Kid, you don't even know just what you don't know. "
--The Dark Lord Sauron
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
