Sciencemadness Discussion Board
Not logged in [Login ]
Go To Bottom

Printable Version  
Author: Subject: Full Design cell for Sodium Perchlorate
SAM4CH
Hazard to Others
***




Posts: 162
Registered: 16-7-2004
Location: TA
Member Is Offline

Mood: PERFECT

[*] posted on 16-12-2006 at 02:21
Full Design cell for Sodium Perchlorate


I need help in design my perchlorate cell!! I get very good results which I can make 2600g per 4days at 120A and 6Volts with no buffer or HCl added! I faced many problems in my 6Liter cell like connection and install the lead dioxide anodes "I past it with fiber and epoxy glue but I faced problem when I like to reinstall new anode if one of them has crack, my anodes number is four and 12mm, 30,5cm Gouging rods coated with 4-5mm PbO2" I need mechanical and chemical help because in last week my cell explode after 10minutes of operation and I think that cause of hydrogen gas but I let Hydrogen to escape through 20mm hole, and my cell provided with Exhaust Fans..
my current cell has these dimensions :
5cm width * 25 hight *50 long cm the case is stainless steel 304 and it is cathode (-)
View user's profile View All Posts By User This user has MSN Messenger
FrankRizzo
Hazard to Others
***




Posts: 200
Registered: 9-2-2004
Member Is Offline

Mood: No Mood

[*] posted on 14-1-2007 at 13:23


Would you mind posting photos of your setup? Also, what are you using for such a high current power supply?

[Edited on 14-1-2007 by FrankRizzo]
View user's profile View All Posts By User
chloric1
International Hazard
*****




Posts: 1039
Registered: 8-10-2003
Location: closer to the anode
Member Is Offline

Mood: Strongly alkaline

[*] posted on 28-7-2007 at 11:56


Shoot I wouldn't mind having a photo of the exploding cell:D;)



In the theater of life its nice to know where the exit doors are located.
View user's profile Visit user's homepage View All Posts By User

  Go To Top