LD5050
Hazard to Others
Posts: 182
Registered: 16-1-2017
Member Is Offline
Mood: No Mood
|
|
concentrating under vacuum
I have a mixture of isopropyl alcohol, water, and oil i want to collect the oil but don't want to get the mixture too hot by means of distilling at
atmospheric pressure. I don't have a cold trap or dry ice or anything so i know I wont be able to condense the alcohol vapors so should i just hook my
vacuum right to the flask and suck them through the vacuum will this work?
|
|
|
CharlieA
National Hazard
Posts: 645
Registered: 11-8-2015
Location: Missouri, USA
Member Is Offline
Mood: No Mood
|
|
Why can't you just allow the isopropanol and water to evaporate at room temperature?
Do you know the boiling point of the oil at atmospheric pressure?
What is the oil?
Do you know how sensitive the oil if to temperature?
Sorry I have so many questions! 
But maybe I can come up with some suggestions later.
|
|
|
JJay
International Hazard
Posts: 3440
Registered: 15-10-2015
Member Is Offline
|
|
I usually try to avoid oil mixtures containing oil and alcohol, but I've found that it is usually possible to distill them off at atmospheric pressure
without a vacuum without losing much product (note that some things will steam distill with water in unacceptable proportions). Can you distill off
the alcohol and water first at atmospheric pressure? Or maybe salt out the water and just distill out the alcohol?
Simply evaporating them under the pump will probably work but will cause wear and tear on the pump. I would probably try condensing the alcohol vapors
even under reduced pressure - the boiling point of isopropyl alcohol really isn't that low. Also, leaving alcohol and water in your pump oil is a bad
idea; water can cause corrosion and alcohol can cause lower viscosity. Both have a vapor pressure and will lower the ultimate minimum pressure of your
pump if allowed to remain in the oil.
[Edited on 16-3-2017 by JJay]
|
|
|
Tsjerk
International Hazard
Posts: 3022
Registered: 20-4-2005
Location: Netherlands
Member Is Offline
Mood: Mood
|
|
This works quite well with a water aspirator without a cold trap as the vapors will be immediately diluted with lots of water.
|
|
|
Liamatpm
Harmless
Posts: 48
Registered: 7-12-2016
Location: Maine
Member Is Offline
Mood: Using the process of cellular respiration to stay (barely) alive
|
|
Are you talking about a vacuum pump or a water type pump or a vacuum cleaner?
|
|
|
Tsjerk
International Hazard
Posts: 3022
Registered: 20-4-2005
Location: Netherlands
Member Is Offline
Mood: Mood
|
|
I'm talking about a water stream type pump. A normal pump will also work but the solvent will degrade the membranes or in case of a oil pump dissolve
in the oil.
|
|
|
Liamatpm
Harmless
Posts: 48
Registered: 7-12-2016
Location: Maine
Member Is Offline
Mood: Using the process of cellular respiration to stay (barely) alive
|
|
Tsjerk I figured but I wasn't very sure.
|
|
|
LD5050
Hazard to Others
Posts: 182
Registered: 16-1-2017
Member Is Offline
Mood: No Mood
|
|
A vacuum cleaner for a lab pump?! has anyone really done this??
|
|
|
Liamatpm
Harmless
Posts: 48
Registered: 7-12-2016
Location: Maine
Member Is Offline
Mood: Using the process of cellular respiration to stay (barely) alive
|
|
I've seen some videos on highly modified vaccum cleaners. It's a waste of money, resources and time but some people do it.
|
|
|
Geocachmaster
Hazard to Others
Posts: 146
Registered: 5-3-2016
Location: Maine, USA
Member Is Offline
Mood: Corroded, just like my spatulas
|
|
How about Tdep before his new one
Youtube video
I use one with some success, only for filtration though. The addition of a vacuum cleaner speeds up filtration quite a bit, but the excessive noise
produced by my 1960s vacuum means I use it only on rare occasions. I'm not sure how low a pressure is actually produced, I can't imagine it's very low
(not less than 400mmhg, ethanol will boil at around 62C for reference). Probably a no go for vacuum distillation.
Soon I will buy a water aspirator, much better
|
|
|
Praxichys
International Hazard
Posts: 1063
Registered: 31-7-2013
Location: Detroit, Michigan, USA
Member Is Offline
Mood: Coprecipitated
|
|
Easy. Just add a bunch of table salt and the isopropanol will layer out and take the oil with it. Decant the isopropanol layer off the water/salt and
evaporate the alcohol with gentle warming.
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
