jimwig
Hazard to Others
Posts: 215
Registered: 17-5-2003
Location: the sunny south
Member Is Offline
Mood: No Mood
|
|
citric acid and sodium benzoate to benzene?
recently read about a scare involving (soft drinks) ingrediates (sodium benzoate and citiric acid) reacting to make benzene.......?
has anyone tried this route to benzene yet? cause i sure love drinking pop and if my stomach could stand the abuse then........
(thats a joke, guys and girls)
i have searched and cannot find a ref that talks about this citric acid route.
i have the benzene via alkaline reaction of sodium benzoate (ala the library) method in mind to try. but the yield is small. it seems.
one of the problems is heating. that is to heat the whole banana (listen before you get your lighters out - i know this NOT a real banana - just
allegory or some such) sooo i was wondering about using the hydroxides and benzoate in a microwave oven.... heating would not be a problem if
something in there is polar.
would have to have a strong non metallic reaction vessel... and then condense via copper tube once the vapor is outside the MO.
what cha think?
craZy jiM wGGns
--packrat, professional bum. -- once just tired
now REtired.
|
|
entropy51
Gone, but not forgotten
Posts: 1612
Registered: 30-5-2009
Member Is Offline
Mood: Fissile
|
|
Jimwig, you may be thinking of asborbic instead of citric acid. I ran across quite a few references to that recently. One is https://www.aibonline.org/researchandtechnical/white%20paper...
It doesn't seem like a good synthetic route to me.
[Edited on 11-6-2009 by entropy51]
|
|
jimwig
Hazard to Others
Posts: 215
Registered: 17-5-2003
Location: the sunny south
Member Is Offline
Mood: No Mood
|
|
i am quite sure all the posts said "citric acid" but like i say i am getting no hits google on that so maybe the posters were wrong.
soft drinks ingredients have citric acid and sodium benzoate on every one i have read lately.
so i guess my state of confusion goes on.
anyone else.
craZy jiM wGGns
--packrat, professional bum. -- once just tired
now REtired.
|
|
entropy51
Gone, but not forgotten
Posts: 1612
Registered: 30-5-2009
Member Is Offline
Mood: Fissile
|
|
JimWig, you said "i have the benzene via alkaline reaction of sodium benzoate (ala the library) method in mind to try. but the yield is small. it
seems."
I usually get over 70% yield of benzene from decarboxylation of sodium benzoate, which I don't consider small for a reaction conducted with lots of
heat and no solvent!
|
|
not_important
International Hazard
Posts: 3873
Registered: 21-7-2006
Member Is Offline
Mood: No Mood
|
|
Ascorbic acid; it appears urban legend is at work.
https://www.aibonline.org/researchandtechnical/white%20paper...
and
http://www.foodsafety.gov/~dms/benzltr.html
The amounts are in the low to sub-parts per billion range, a bit lower than those from heating dry sodium benzoate to toasty temperatures.
[Edited on 12-6-2009 by not_important]
|
|
jimwig
Hazard to Others
Posts: 215
Registered: 17-5-2003
Location: the sunny south
Member Is Offline
Mood: No Mood
|
|
1- OTC and
i have read the posts by ordenblitz et al and the return was less than 70Percent.
could you detail a little of your process other than what is written in the member's publications/board?
this excites me because
1- OTC and
2-OT fucking C!!!!!!
thanks
also thanks to notimpotent (sp?) for a direct hit on my question and a thanks you sir!!!!
[Edited on 12-6-2009 by jimwig]
[Edited on 12-6-2009 by jimwig]
anythought concerning the use of a microwave oven in conjuction with the process?
[Edited on 12-6-2009 by jimwig]
craZy jiM wGGns
--packrat, professional bum. -- once just tired
now REtired.
|
|
entropy51
Gone, but not forgotten
Posts: 1612
Registered: 30-5-2009
Member Is Offline
Mood: Fissile
|
|
My benzene prep is more like Magpie's than Ordenblitz', due to the small scale I use.
18 gm benzoic acid and 15 gm NaOH are dissolved in water and evaporated to dryness in a steel basin, then pyrolyzed in a thin layer in a small RB or
pear flask attached to a condenser and receiver. I use a Bunsen flame, and turn the flask on its side with the benzoate spread over the wall. The
flask doesn't last forever, but I have a large supply of flasks that were extremely cheap, and I don't do this prep every day. Typical yield after
drying product over CaCl2 and distilling is about 8.4 gms, or about 73%. About 1 mL of dark orange residue is left in the distilling flask, but the
benzene is colorless.
Ordenblitz has me beat for sheer amount of product, but this one may be of use to some. I have a feeling you are thinking of larger scale.
|
|
jimwig
Hazard to Others
Posts: 215
Registered: 17-5-2003
Location: the sunny south
Member Is Offline
Mood: No Mood
|
|
yes larger scale and starting with sodium benzoate and the hydroxide.
but tell me what you think of using a microwave oven.
are either one of my starters polar? i think not.....?
just test them --- crazy i am !!!
[Edited on 17-6-2009 by jimwig]
craZy jiM wGGns
--packrat, professional bum. -- once just tired
now REtired.
|
|
jimwig
Hazard to Others
Posts: 215
Registered: 17-5-2003
Location: the sunny south
Member Is Offline
Mood: No Mood
|
|
sodium hydroxide is polar
sodium hydroxide is polar and therrefore will heat up in a microwave oven. yeah!!!
that means the reaction of NaOH with sodium benzoate in a ceramic retort heated in a microwave oven should produce benzene. and i am chomping at the
bit to do just that.
benzene along with phosphorus and sodium trioxide seem to the top three hard to prepare chemicals. at least for now.. so this might be significant
anyone else interested?
i know i am probably talking to myself here but WTF........
craZy jiM wGGns
--packrat, professional bum. -- once just tired
now REtired.
|
|
peach
Bon Vivant
Posts: 1428
Registered: 14-11-2008
Member Is Offline
Mood: No Mood
|
|
I was having a search around on google and found this thread.
I would give a word of caution against heating NaOH / KOH in the microwave. If any of it spills or spatters on the glass turn table, it can get super
hot in that spot. This is precisely the method by which the platter in mine exploded upon opening the door, as the cold air entered and the stress in
the glass became too much. As the glass is toughened, it holds a lot of energy before bursting. I found finger sized shards of mine on the other side
of the room. It went with an extremely loud bang; like a firework right in front of me.
That aside, I have run the benzoate / naoh method just yesterday. It's given 140-150ml of crude, fluorescent orange produce from 400g of benzoate.
Mmmmm.... yuck!
[Edited on 28-4-2011 by peach]
|
|
Arthur Dent
National Hazard
Posts: 553
Registered: 22-10-2010
Member Is Offline
Mood: entropic
|
|
Hey Peach... good to have you back, I missed your colorful posts my friend! It's been a while...
Very cool ghetto boiler setup!
Robert
--- Art is making something out of nothing and selling it. - Frank Zappa ---
|
|