zinc finger - 16-11-2021 at 10:44
I have a PL AS RT Autosampler but no control software. I think one can control it with the Agilent GPC/SEC software and there probably is an older software called "PL instrument control software" which I could not find.
Can anyone tell me where I can find a copy of this software for free?
Alternatively, I already figured out the parameters of the serial port to be:
Baud = 19200
Data = 8 Bit
Stop = 1
Parity = None
The console is in ASCII with CR at the end of each line. No bootup message appears but I could trigger several Errors in the form of "ERR(00)". The
device reboots when "=" is send as command. Has someone an idea which commands I should try?
unionised - 16-11-2021 at 11:37
I'd be a little surprised if Agilent's software will drive Varian's kit.
zinc finger - 16-11-2021 at 12:00
In the manual it says "Please note that Varian, INC. is now part of Agilent Technologies." and the same autosampler is afaik still sold as part of the
GPC 50+ system under the brand Agilent together with aforementioned software.
Or am I overlooking something? 