I am conducting research on the melting and casting explosives of ETN, potassium chlorate, and sodium benzoate. In my area, flat plate crater
testing (SSRT) cannot be conducted. I hope some friends can help me with the testing.
requirement: ETN，KCLO3， Sodium benzoate needs to be mixed evenly before being melted and cast in hot waterPlease do not
place it on the heater during casting Interested parties can contact me privately through U2U and inquire about detailed matching. Thank youMineMan - 5-1-2025 at 14:46
That seems like a very dangerous mix. And one that will greatly enhance DDT properties of the ETN. Expect sensitivity to increase as well. IMO, I
would not recommend.
Sir_Gawain - 5-1-2025 at 14:50
Sounds similar to whistle mix. Melting this mixture seems like a very bad idea. Laboratory of Liptakov - 6-1-2025 at 00:21
That seems a like activity of AI. That is, a question or request created by artificial intelligence from posts written in the last month. The question
is asked awkwardly and partially makes no sense. Perhaps it is only intended to collect data about active users.CEML - 12-1-2025 at 01:04
sorry,I'm not in a English spoken country,so I have to use some apps to correct my grammar mistakesCEML - 15-1-2025 at 03:40
Quote:
Sounds similar to whistle mix. Melting this mixture seems like a very bad idea.
In fact, it is only the melting of ETN, not including sodium benzoate, and its sensitivity is not high. I need a lot of energy to stimulate it with a
hammer. I use it as the main charge, which means that detonators need to be detonated. Here is the ratio: potassium chlorate: sodium benzoate:
etn=16:5:21
I am writing a related paper. I hope someone can help me
