Sciencemadness Discussion Board
Not logged in [Login ]
Go To Bottom

Printable Version  
Author: Subject: Hyaluronic acid
Xrpdguy
Hazard to Self
**




Posts: 51
Registered: 28-2-2018
Location: Serbia
Member Is Offline

Mood: Suspicious

cool.gif posted on 14-1-2019 at 04:38
Hyaluronic acid


Hey guys, did anyone try ever to isolate hyaluronic acid from rooster's comb?
I have tried but something went wrong i suppose or it was a 'rooster without acid'.:D
View user's profile View All Posts By User
Xrpdguy
Hazard to Self
**




Posts: 51
Registered: 28-2-2018
Location: Serbia
Member Is Offline

Mood: Suspicious

[*] posted on 15-1-2019 at 05:02


The collected rooster combs were washed under tap
water to remove all dirt and blood stains followed by
distilled water wash. The rooster combs were weighed,
and 5 grams of rooster combs were taken in Hyaluronic acid extraction.
To start with the experiment the
Rooster combs were cut into small pieces with the help
of clean stainless steel chopper. The collected pieces of
combs were ground in an electric grinder were suspended in 100 ml acetone and were stored at 8 degrees of celsius.
After 24 hours the acetone was squeezed from the
cock's comb, and additional acetone was added. This
was repeated ten times at 24 hours interval. After the
last extraction, the remaining acetone was evaporated
in a steam of air. The dried form of
combs was then extracted ten times successively with
100 ml of 5% of Sodium acetate. Each time the viscous fluid was squeezed through several layers of
cheesecloth.
1.5 L of ethanol was added to the aqueous extract. The
precipitate was centrifuged, and dissolved in 5% sodium
acetate solution, and centrifuged again.

And now what? I just have a solution of nothing. Do you think this is the right way?

After all procedure acid should be precipitated by adding ethanol but nothing happened at all.
View user's profile View All Posts By User
TheMrbunGee
Hazard to Others
***




Posts: 364
Registered: 13-7-2016
Location: EU
Member Is Offline

Mood: Phosphorising

[*] posted on 15-1-2019 at 06:53


Quote: Originally posted by Xrpdguy  
The collected rooster combs were washed under tap
water to remove all dirt and blood stains followed by
distilled water wash. The rooster combs were weighed,
and 5 grams of rooster combs were taken in Hyaluronic acid extraction.
To start with the experiment the
Rooster combs were cut into small pieces with the help
of clean stainless steel chopper. The collected pieces of
combs were ground in an electric grinder were suspended in 100 ml acetone and were stored at 8 degrees of celsius.
After 24 hours the acetone was squeezed from the
cock's comb, and additional acetone was added. This
was repeated ten times at 24 hours interval. After the
last extraction, the remaining acetone was evaporated
in a steam of air. The dried form of
combs was then extracted ten times successively with
100 ml of 5% of Sodium acetate. Each time the viscous fluid was squeezed through several layers of
cheesecloth.
1.5 L of ethanol was added to the aqueous extract. The
precipitate was centrifuged, and dissolved in 5% sodium
acetate solution, and centrifuged again.

And now what? I just have a solution of nothing. Do you think this is the right way?

After all procedure acid should be precipitated by adding ethanol but nothing happened at all.



"Five hundred grams of frozen rooster combs yielded about 500 mg of dried HA"

You might have 5 mg of HA, If you have checked the numbers in this post of yours.. It also seems to be soluble in water, so I would not waste so much valuable solvent.




View user's profile Visit user's homepage View All Posts By User

  Go To Top