Sciencemadness Discussion Board
Not logged in [Login ]
Go To Bottom

Printable Version  
Author: Subject: High speed chips from chiseling
wg48temp9
International Hazard
*****




Posts: 604
Registered: 30-12-2018
Location: not so United Kingdom
Member Is Offline


[*] posted on 21-6-2021 at 10:20
High speed chips from chiseling


The usual advice for the care of cold chisels is to grind off the mushroomed head to avoid the dangers of flying metal chips. I have never had a problem of flying metal chips or I hadn't until yesterday.

I was using a cold chisel to attempt to prise off a sleeve from a shaft On one swift hit of the chisel with a hammer I felt an intense pain in one of my fingers which began to bleed. Apparently a flying small chip of metal had punctured the end of my middle finger. The chisel was new and not mushroomed. On consideration of the position of the puncture in relation to the chisel, the chip was probably piece of the hardened (assumed) steel sleeve.

Unfortunately today the area round the puncture is red and tender. I had assumed the chip was large compared to puncture. I checked with a strong magnets, I can feel an attraction so the metal chip is under the skin The metal chip must be small but was moving so fast it is now a millimeter or more below skin surface.

When I have dug the metal chip out I will take a picture of it and post it. When the wound was fresh I may have been able to pull the chip with the strong magnet. No MRIs for me.

Of course the morel of the story is wear hand and eye protection for such operations.

PS: I manged to get the chip out. Its about 2 x 3 mm across and much less than millimeter in thickness. Probably a few mg in mass. I am very surprised it had sufficient velocity to penetrate the relatively tough
skin of my finger tip.

[Edited on 6/21/2021 by wg48temp9]




I am wg48 but not on my usual pc hence the temp handle.
Thank goodness for Fleming and the fungi.
Old codger' lives matters, wear a mask and help save them.
Be aware of demagoguery, keep your frontal lobes fully engaged.
I don't know who invented mRNA vaccines but they should get a fancy medal and I hope they made a shed load of money from it.
View user's profile View All Posts By User
zwt2
Harmless
*




Posts: 14
Registered: 3-9-2019
Member Is Offline

Mood: mango mango mango mango mangooooo

[*] posted on 21-6-2021 at 11:09


Quote:
the morel of the story

Morel_Mushroom-1 - Copy.jpg - 120kB




"Since you belong to the small number of wise men, tell me, pray, how do you occupy yourselves?"
View user's profile View All Posts By User
unionised
International Hazard
*****




Posts: 4628
Registered: 1-11-2003
Location: UK
Member Is Offline

Mood: No Mood

[*] posted on 21-6-2021 at 11:37


I'm not sure of the date, but the tree we were dropping was an elm- it had Dutch elm disease. That suggests about 1975 and that's close enough.
I wasn't really doing much- I was a schoolkid. But I was "helping out" in the way kids do.
The tree was down and we (well, the adults) were breaking up the tree so they could burn it.
And they were using wedges and a sledge hammer.

The bit that came off the mushroomed head of the wedge hit my right thumb- just where the nail bed ends.


I was young, so the wound healed quickly enough, but the nail on that thumb is still distorted.

So, yes, it's an important issue which is easy to overlook.
If the heads on the wedges are getting mushroomed, grind them back to shape.

View user's profile View All Posts By User
unionised
International Hazard
*****




Posts: 4628
Registered: 1-11-2003
Location: UK
Member Is Offline

Mood: No Mood

[*] posted on 21-6-2021 at 11:41


Quote: Originally posted by zwt2  
Quote:
the morel of the story


I see you are the Fun Guy around here.
View user's profile View All Posts By User

  Go To Top