Sciencemadness Discussion Board
Not logged in [Login ]
Go To Bottom

Printable Version  
Author: Subject: Weird Styphnic Acid Behaviour
xonu
Harmless
*




Posts: 14
Registered: 20-5-2019
Location: Ukrainian Soviet Socialist Republic
Member Is Offline

Mood: dissassociating

[*] posted on 1-11-2021 at 01:11
Weird Styphnic Acid Behaviour


I keep running into a weird issue with making TNR, after sulphonating resorcinol, I get no exotherm on the addition of HNO3, instead it tends to "dump" all of that heat after additions (which caused a nitration runaway on my first attempt) I managed to do the synthesis successfully once without the runaway reaction, but I had the same no-exotherm problem on my latest attempt, which made me quench the reaction mix instead of carrying on.

Am I "overcooling" the reaction mix or am I simply too fast with my additions? I'm following a scaled-down version of the Powerlabs prep for it and I can post it here if needed.




meow
View user's profile Visit user's homepage View All Posts By User
Tsjerk
International Hazard
*****




Posts: 3022
Registered: 20-4-2005
Location: Netherlands
Member Is Offline

Mood: Mood

[*] posted on 1-11-2021 at 03:59


I don't know this specific reaction, but it sounds like overcooling indeed. The reaction needs some temperature to proceed and when it does get up to speed, either because of a higher temperature or a higher concentration of nitric acid, there is already too much nitric available to keep the temperature under control. I would raise the temperature until you do see the exotherm before adding more nitric.

[Edited on 1-11-2021 by Tsjerk]
View user's profile View All Posts By User
xonu
Harmless
*




Posts: 14
Registered: 20-5-2019
Location: Ukrainian Soviet Socialist Republic
Member Is Offline

Mood: dissassociating

[*] posted on 1-11-2021 at 06:57


Guessed so, I once started the addition outside the icebath and only started cooling when the exotherm started, and it worked out fine with no runaway during the next step.



meow
View user's profile Visit user's homepage View All Posts By User
caterpillar
Hazard to Others
***




Posts: 472
Registered: 8-1-2012
Member Is Offline

Mood: No Mood

[*] posted on 1-11-2021 at 20:08


My first attempt to prepare TNR failed- I tried just like I did it with phenol. But resorcinol after contact with sulfur acid turned to stone. Later I made TNR, using a two-stage process- nitrosation and then nitration with diluted nitric acid. No concentrated acids at all.



Women are more perilous sometimes, than any hi explosive.
View user's profile Visit user's homepage View All Posts By User
xonu
Harmless
*




Posts: 14
Registered: 20-5-2019
Location: Ukrainian Soviet Socialist Republic
Member Is Offline

Mood: dissassociating

[*] posted on 2-11-2021 at 00:22


Weird, mine forms a dark red thick goop that feels like a very viscous jam, it thins out on addition of HNO3



meow
View user's profile Visit user's homepage View All Posts By User
caterpillar
Hazard to Others
***




Posts: 472
Registered: 8-1-2012
Member Is Offline

Mood: No Mood

[*] posted on 2-11-2021 at 04:42


Quote: Originally posted by xonu  
Weird, mine forms a dark red thick goop that feels like a very viscous jam, it thins out on addition of HNO3

Dark red, yeah, but solid. I threw it away. The method that I described here worked fine.




Women are more perilous sometimes, than any hi explosive.
View user's profile Visit user's homepage View All Posts By User

  Go To Top