Ankit1612
Harmless
Posts: 32
Registered: 2-11-2022
Member Is Offline
|
|
chlorate cell
|
|
|
mysteriusbhoice
Hazard to Others
Posts: 473
Registered: 27-1-2016
Member Is Offline
Mood: Became chemistry catboy Vtuber Nyaa
|
|
I dont think your image loaded meanwhile enjoy some modified MMO with PbO2.
|
|
|
Ankit1612
Harmless
Posts: 32
Registered: 2-11-2022
Member Is Offline
|
|
I need some help:
I have Graphite electrode dia. 16mm, length 3 inch and 220W CPU SMPS power supply.
And I prepared a 400ml sodium chlorate cell.
I made a saturated solution of 450 ml of distilled water and 150 g of sodium chloride (edible salt) and added 6 ml of conc. HCl to make the solution
acidic. Then I took a 500 ml beaker and put 400 ml saturated salt solution in it. CPU SMPS have 3.3v, 5v and 12v. I have connected 5V supply to the
cell.
Now I am confused that, at how many volts this CPU SMPS will gives how much current.
I also want to know for how many days I have to run the cell in order to get enough amount of sodium chlorate?
[Edited on 2-1-2023 by Ankit1612]
|
|
|
mysteriusbhoice
Hazard to Others
Posts: 473
Registered: 27-1-2016
Member Is Offline
Mood: Became chemistry catboy Vtuber Nyaa
|
|
you need to make a shunt or buy a shunted meter
https://www.youtube.com/watch?v=oWT8gfQLn24
runtime calculators can be found online
just run either 3.3V or 5V pref 3.3 for graphite since it runs at low current density.
|
|
|
woelen
Super Administrator
Posts: 7976
Registered: 20-8-2005
Location: Netherlands
Member Is Offline
Mood: interested
|
|
Adding 6 ml of conc. HCl seems too much to me. Formation of chlorate does not occur at too low pH. Chlorate is formed from Cl2 and OH(-) ions and
these will hardly be present with so much HCl in the mix.
What you can do is add a power diode in series with the 5V supply if the 3.3V is too low and the 5V supply is too high. Such a power diode will take
away 0.7 to 0.8 volts at a current of several amperes. Be sure to cool the diode, at e.g. 6A it consumes 4 to 5 Watts of power and it will become VERY
hot without proper cooling.
|
|
|
Ankit1612
Harmless
Posts: 32
Registered: 2-11-2022
Member Is Offline
|
|
so far its been 24 hours since the cell started at 5v. Now, should I power it to 3.3 volt. I checked the temperature, it was 28°C, at the bottom and
39°C near the electrode.
Now what should I do?
|
|
|
Ankit1612
Harmless
Posts: 32
Registered: 2-11-2022
Member Is Offline
|
|
can anyone tell me about that;
it was on my CPU SMPS.
[Edited on 3-1-2023 by Ankit1612]
|
|
|
mysteriusbhoice
Hazard to Others
Posts: 473
Registered: 27-1-2016
Member Is Offline
Mood: Became chemistry catboy Vtuber Nyaa
|
|
this PSU looks like the 400 or 300 watt variant and anyways you have a lot of amps to use. Highly doubt you will even get close to running it more
than 8 amps with your electrode
|
|
|
Ankit1612
Harmless
Posts: 32
Registered: 2-11-2022
Member Is Offline
|
|
It means I will get 40A at 5V..!
|
|
|
mysteriusbhoice
Hazard to Others
Posts: 473
Registered: 27-1-2016
Member Is Offline
Mood: Became chemistry catboy Vtuber Nyaa
|
|
That is the maximum you will get before it shuts down or shits itself. This likely wont reach values anywhere near 40 amps unless you have large
enough electrodes with low enough resistance which dinky graphite rods simply wont make that possible unless you dead short them.
|
|
|
Rainwater
National Hazard
Posts: 799
Registered: 22-12-2021
Member Is Offline
Mood: indisposition to activity
|
|
Yes, for a short time. As the unit runs at that high of a current, it will heat up. Hotter it gets, less power you can draw.
But thats just a starting point. You need current control.
Thats more important than voltage.
You need something like
ACEIRMC 20A 300W CC CV Step Down Module Adjustable DC 6-40V ...
https://www.amazon.com/Aceirmc-Converter-Adjustable-Regulato...
Your gonna want to watch that current aswell.
I like this
DC Multifunction Battery Monitor Meter,0-300V,0-100A Built-in Shunt ...
https://www.amazon.com/Multifunction-Battery-Monitor-Display...
[Edited on 5-1-2023 by Rainwater]
"You can't do that" - challenge accepted
|
|
|
mysteriusbhoice
Hazard to Others
Posts: 473
Registered: 27-1-2016
Member Is Offline
Mood: Became chemistry catboy Vtuber Nyaa
|
|
based on his setup I highly doubt he is gonna have a chance at running 40 amps
|
|
|
yobbo II
National Hazard
Posts: 709
Registered: 28-3-2016
Member Is Offline
Mood: No Mood
|
|
I need some help:
Try here
http://www.chlorates.exrockets.com/chlorate.html
Yob
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
