CEML
Harmless
Posts: 3
Registered: 10-12-2024
Member Is Offline
|
|
ETN mixed energetic material testing help
I am conducting research on the melting and casting explosives of ETN, potassium chlorate, and sodium benzoate. In my area, flat plate crater
testing (SSRT) cannot be conducted. I hope some friends can help me with the testing.
requirement: ETN,KCLO3, Sodium benzoate needs to be mixed evenly before being melted and cast in hot waterPlease do not
place it on the heater during casting
Interested parties can contact me privately through U2U and inquire about detailed matching. Thank you
|
|
MineMan
International Hazard
   
Posts: 1023
Registered: 29-3-2015
Member Is Offline
Mood: No Mood
|
|
That seems like a very dangerous mix. And one that will greatly enhance DDT properties of the ETN. Expect sensitivity to increase as well. IMO, I
would not recommend.
|
|
Sir_Gawain
Hazard to Others
 
Posts: 478
Registered: 12-10-2022
Location: [REDACTED]
Member Is Offline
Mood: Still in 2022
|
|
Sounds similar to whistle mix. Melting this mixture seems like a very bad idea.
“Alchemy is trying to turn things yellow; chemistry is trying to avoid things turning yellow.” -Tom deP.
|
|
Laboratory of Liptakov
International Hazard
   
Posts: 1443
Registered: 2-9-2014
Location: Tel Aviv University
Member Is Offline
Mood: old jew
|
|
That seems a like activity of AI. That is, a question or request created by artificial intelligence from posts written in the last month. The question
is asked awkwardly and partially makes no sense. Perhaps it is only intended to collect data about active users.
Development of primarily - secondary substances: CHP (2015) neutral CHP and Lithex (2022) Brightelite (2023) Nitrocelite and KC primer (2024) Diper
60 (2025)
|
|
CEML
Harmless
Posts: 3
Registered: 10-12-2024
Member Is Offline
|
|
sorry,I'm not in a English spoken country,so I have to use some apps to correct my grammar mistakes
|
|
CEML
Harmless
Posts: 3
Registered: 10-12-2024
Member Is Offline
|
|
Quote: | Sounds similar to whistle mix. Melting this mixture seems like a very bad idea. |
In fact, it is only the melting of ETN, not including sodium benzoate, and its sensitivity is not high. I need a lot of energy to stimulate it with a
hammer. I use it as the main charge, which means that detonators need to be detonated. Here is the ratio: potassium chlorate: sodium benzoate:
etn=16:5:21
I am writing a related paper. I hope someone can help me
|
|