Dr.Arz
Harmless
Posts: 26
Registered: 14-10-2014
Member Is Offline
Mood: No Mood
|
|
High temp liquids in heating mantle and how to circulate
If there becomes a need to control temperature of a tube, lets say utilized from ordinary distilling bridge, as a furnace-type catalyte-filled tube,
what liquids could be used between 100 and 300C and how to circulate them between the mantle and the bank? One option could be using air bubble tube
to transfer it into higher reserve where it can flow through the mantle and there back to collecting bin. I thought of using some sort of liquid
because temp control and stability would be very high compared to air heating. Need would be to heat tube to approx 200C. Commercial versions are
listed like Therminol which is usable to over 350C.
A side question too, how hard it should be to construct thermostat to a hot air gun? Needs some electrical connections for sure..
[Edited on 20-10-2014 by Dr.Arz]
|
|
|
macckone
International Hazard
Posts: 2159
Registered: 1-3-2013
Location: Over a mile high
Member Is Offline
Mood: Electrical
|
|
Many hot air guns come with a thermostat built in.
Some commercial models also have exterior thermocouple control.
|
|
|
WGTR
National Hazard
Posts: 971
Registered: 29-9-2013
Location: Online
Member Is Offline
Mood: Outline
|
|
63/37 tin lead solder melts at about 180C. A U-shaped tube immersed in a molten metal bath would provide good temperature consistency along the
reactor tube. Failing that, drill or mill a hole in a block of aluminum, and run the tube through that. The aluminum can be heated on a hot plate,
and fire bricks can be used to insulate the surface.
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
