Sciencemadness Discussion Board
Not logged in [Login ]
Go To Bottom

Printable Version  
Author: Subject: Vacuum distilling high MP substance?
Dr.Arz
Harmless
*




Posts: 26
Registered: 14-10-2014
Member Is Offline

Mood: No Mood

[*] posted on 24-10-2014 at 08:52
Vacuum distilling high MP substance?


How can one distill a compound that has high mp and high bp at ntp in a vacuum so that the substance doesn't solidify upon condensation? This is because I understand that lowering pressure only lowers bp, not mp. Therefore if we have compound that melts at 90C and boils at 300C and we distill it at 10mbar at 172C, doesn't it solidify almost instantly when touching the cold condenser? Should one circulate almost boiling water and immerse the receiving flask to a hot bath in order to keep it liquid until it is done?
View user's profile View All Posts By User
Nicodem
Super Moderator
*******




Posts: 4230
Registered: 28-12-2004
Member Is Offline

Mood: No Mood

[*] posted on 24-10-2014 at 09:19


Depends on the scale, but if you just distilling a few dozens of grams, then you just use an air cooled condenser and initially help your self with a heat gun.



…there is a human touch of the cultist “believer” in every theorist that he must struggle against as being unworthy of the scientist. Some of the greatest men of science have publicly repudiated a theory which earlier they hotly defended. In this lies their scientific temper, not in the scientific defense of the theory. - Weston La Barre (Ghost Dance, 1972)

Read the The ScienceMadness Guidelines!
View user's profile View All Posts By User
Metacelsus
International Hazard
*****




Posts: 2531
Registered: 26-12-2012
Location: Boston, MA
Member Is Offline

Mood: Double, double, toil and trouble

[*] posted on 24-10-2014 at 10:02


You could set it up as a sublimation, perhaps. The compound won't be subliming, but it will be depositing.



As below, so above.

My blog: https://denovo.substack.com
View user's profile View All Posts By User
Oxirane
Hazard to Self
**




Posts: 92
Registered: 19-9-2014
Member Is Offline

Mood: No Mood

[*] posted on 25-10-2014 at 02:56


One could maybe make a vacuum reflux setup as a sublimator for smaller amounts? The crystals would deposit on the water cooled reflux condenser and when it is done, use pure solvent to dissolve it and evaporate to get pure product. Actually one could deposit quite a large amounts if large reflux column is used. I believe this could be quite a way to make food grade ammonium chloride. :P

[Edited on 25-10-2014 by Oxirane]
View user's profile View All Posts By User

  Go To Top