kine
Harmless
Posts: 26
Registered: 8-8-2005
Member Is Offline
Mood: No Mood
|
|
Quick question
I am kooking for a gas catalist that will increase the burn rate of gasoline/air mix with out detonation. The purpose is to use it in an car injection
for gaining horsepower. I know more oxygen will do that but there is a danger for detonation.
Thanks for any help.
|
|
unionised
International Hazard
Posts: 5128
Registered: 1-11-2003
Location: UK
Member Is Offline
Mood: No Mood
|
|
I thought that modern engines burned a near stoichiometric fuel-air mixture. Too much O2 and you get NOx, too little O2 and you get lots of unburned
fuel. If I'm right about that then it clearly burns fast enough anyway, the only way to increase the power would be to raise the RPM and that isn't
healthy for the engine.
Anyway, almost anything that raised the reaction rate would be likely to lead to detonation. If there were a suitable catalyst then people would have
found out about it by now and we would all be using it.
|
|
kine
Harmless
Posts: 26
Registered: 8-8-2005
Member Is Offline
Mood: No Mood
|
|
It seems that the only way to increase the burn rate of fuel/air mix is detonation. I am planing to decrease the amount of injection on an old car to
1/4 and add a catalyst to the fuel so it will be detonatable, hoping that the tiny amount of fuel/oxygen(detonatable) mix entering the combustion
chamber won't harm the pistons or any other construction.
Any sugestions on the kind of material would raise the rate of reaction to detonation?
|
|
quicksilver
International Hazard
Posts: 1820
Registered: 7-9-2005
Location: Inches from the keyboard....
Member Is Offline
Mood: ~-=SWINGS=-~
|
|
What you MAY be looking for is used in motorcycle engines as an additive. It is nitro propane and etoh but you would certainly need to adust the
computer 1st for the fuel injector. The liklyhood is that it would wear the motor down regardless due to simply higher force generated at time of
combustion. It is commonly available wherever motorcycle proformance products are sold.
|
|
franklyn
International Hazard
Posts: 3026
Registered: 30-5-2006
Location: Da Big Apple
Member Is Offline
Mood: No Mood
|
|
Bah Humbug
Unionized is right
A modern auto engine is so well engineered that practically any aftermarket
modification or addition you may do to it will deleteriously diminish either
drivability or mileage or both. This has been proven time and again by testing
at underwriters laboratories and consumer reports. Fuel additives continue to
be a perennial hoax. http://pesn.com/2005/03/17/6900069_Acetone
Racing fuels are specifically blended and are not made up with " additives "
since the components are significant percent fractions of the blend. Antiknock
properties need only to be enhanced if the engine has very high compression or
is supercharged. Methyl Tertiary-Butyl Ether MBTE used in gasoline after
Tetra-ethyl lead was found to impair catalytic convertors is itself a ground water
contaminant given its affinity for water is being phased out and already banned
in many jurisdictions. http://en.wikipedia.org/wiki/MBTE
Because much of an engines specifications are set from a controller there isn't
really anything you can adjust yourself except as stated here at the begining.
If you're looking for remarkable performance boost by putting a little something
in the tank, it just won't happen.
All of this is rapidly becoming moot as the economy shifts over time to hybrid
vehicles where the engine will run at an optimal speed continuosly when it is on,
and it will turn on by itself or off as power demands warrant. The driver will only
steer, brake or accelerate.
[Edited on 23-12-2006 by franklyn]
|
|
kine
Harmless
Posts: 26
Registered: 8-8-2005
Member Is Offline
Mood: No Mood
|
|
well i will wait for the pulse detonation engine to come out then some time in the future....
thanks for the info
[Edited on 23-12-2006 by kine]
|
|
Sickman
Hazard to Self
Posts: 98
Registered: 9-5-2004
Member Is Offline
Mood: Icy and I see!
|
|
I'm thinking the best you can do for a little more performance, without getting a bigger engine, is:
1. Make sure your spark plugs are not fouled, and make sure they are properly set to the right gap distance.
2. Use Premium gas instead of regular unleaded. Keep your gas tank only half full, this reduces the overall wieght of your car.
3. Remove any unecessary items from your car that add wieght to it, as for yourself you might want to consider a better diet and more excercise (
every pound less will make your car accelerate faster and you'll get better mileage)!
|
|
h0lx
Hazard to Self
Posts: 69
Registered: 31-12-2005
Member Is Offline
|
|
excercise? normal people GAIN with excercise as they ingrease in muscular mass.
|
|
neutrino
International Hazard
Posts: 1583
Registered: 20-8-2004
Location: USA
Member Is Offline
Mood: oscillating
|
|
Quote: | Originally posted by Sickman
2. Use Premium gas instead of regular unleaded. |
No. Just no. Unless you're driving at high altitudes or towing a very heavy load, you won't need premium.
Two articles I found through 3 seconds of Googling:
straightdope
USAToday
Quote: | No data show that engines designed strictly for regular run better or longer on premium.
The Federal Trade Commission, in a consumer notice, emphasizes: "(I)n most cases, using a higher-octane gasoline than your owner's manual recommends
offers absolutely no benefit. It won't make your car perform better, go faster, get better mileage or run cleaner."
There is "no way of taking advantage of premium in a regular-grade car," says Furey.
"There is no gain. You're wasting money," insists Jim Blenkarn, in charge of powertrains at Nissan in the USA.
"No customer should ever be deluded into thinking there's any value in buying a higher grade of octane than we specify," says Toyota's Paul
Williamsen, technical expert and trainer. |
When you see the gas station advertising that their premium gas has engine scrubbing chemicals that make the gas burn cleaner, remember two things:
1. By US law, all three grades have the same additives
2. Gas stations buy premium for ~8 cents more than regular and sell it for ~20 cents more. Guess which grade gives them a better profit margin?
|
|
Sickman
Hazard to Self
Posts: 98
Registered: 9-5-2004
Member Is Offline
Mood: Icy and I see!
|
|
Quote: | Originally posted by h0lx
excercise? normal people GAIN with excercise as they ingrease in muscular mass. |
Unfortunatley, unless your from a third world country, the normal person you see at walmart or whatever is like 30 pounds or more over wieght. While
it's true that some of the fat will be converted to more muscle if you are intaking enough protien in your diet. Over all, a healthy person that runs
two miles a day is going to wiegh less than the twinky eating fat ass that is always on the couch, and uses his car to take the trash out (I see them
do it all the time).
My point is the overall wieght of your car is basically the most important deciding factor for performance as far as accelaration and gas mileage go.
For example look at the excellent engine to overall wieght ratio of a crotch rocket motercycle compared to a semitruck. Most race cars use materials
like aluminum engine blocks, sometimes magenesium alloys as well, in combination with carbon fiber frames and paneling. This is all to reduce the
weight in order to boost performance and gas mileage.
|
|
neutrino
International Hazard
Posts: 1583
Registered: 20-8-2004
Location: USA
Member Is Offline
Mood: oscillating
|
|
With this in mind, a liposuction can be thought of as an investment in your car to save fuel costs.
Liposuction --> better gas mileage
I wonder if there is some way to use this as a tax loophole. If some crazy lawyer could think of a way to write off liposuctions on tax returns, the
lipo business would be set to explode. Maybe if we could get the departments of transportation or energy to subsidize this...
The downside would be that Americans would see this as a license to eat even more crap and end up with heart conditions because lipo doesn't scrub out
arteries. Actually, no, this would be a good thing. Natural selection in action.
|
|
12AX7
Post Harlot
Posts: 4803
Registered: 8-3-2005
Location: oscillating
Member Is Offline
Mood: informative
|
|
Stranger things have happened. Eh, I heard that a male (obviously) porn star got a tax writeoff on his penile enhancement...
Tim
|
|
h0lx
Hazard to Self
Posts: 69
Registered: 31-12-2005
Member Is Offline
|
|
I disagree with that, when you are from the northern europe (like estonia or scandinavia), which aint 3rd world countries, you see that maybe 1 people
from 50 you encounter is notably overweight.
|
|
gregxy
Hazard to Others
Posts: 421
Registered: 26-5-2006
Member Is Offline
Mood: No Mood
|
|
HaHaHa
You could also save the fat that is lipposuctioned off and
convert it into biodiesel and burn it in your car for even
more fuel savings! 30 pounds of fat is probably 3 gallons
of fuel. Kind of expensive fuel though!
|
|
Boomer
Hazard to Others
Posts: 190
Registered: 11-11-2005
Member Is Offline
Mood: No Mood
|
|
I once put the oxygen line of my welder into the air intake of my car. As soon as I opened the valve, the car hopped like a frog. Not what I call
performance increase.
If you've got a regulated cat converter, whatever you change will be counter-regulated by the closed loop that tries to keep lambda at 1.0!
|
|
enhzflep
Hazard to Others
Posts: 217
Registered: 9-4-2006
Member Is Offline
Mood: No Mood
|
|
To get more horsepower out of your car you can really advance the timing quite a bit. The obvious problem as you mention is the resultant detonation.
Have a look into photoabsorbers - Toluene acts as one. Basically, at the extreme conditions found in the engine during detonation, it has been found
(by whom, I don't recall. Nor where I read it) that quite a bit of the reaction is in fact initiated by the light produced by the fuel burned thus
far!! I'd always asumed it was due to other factors, i.e temp pressure etc.
Toluene it would seem is able to absorb these emmisions and quell the detonation. Though surprisingly it isn't good for the rubber seals used in the fuel system by some manufacturers. I've read reports that indicate
upwards of 75% are ok - no good if you're the other 25% and find out the hard, EXPENSIVE way though.
Came accros this info when looking for a source of toluene for other purposes.
|
|
12AX7
Post Harlot
Posts: 4803
Registered: 8-3-2005
Location: oscillating
Member Is Offline
Mood: informative
|
|
Not suprising, benzene works nicely in engines, as I recall. Toluene is almost benzene...
Tim
|
|
Fleaker
International Hazard
Posts: 1252
Registered: 19-6-2005
Member Is Offline
Mood: nucleophilic
|
|
Benzene, toluene, and xylenes are all used in high test ''race gases''.
Neither flask nor beaker.
"Kid, you don't even know just what you don't know. "
--The Dark Lord Sauron
|
|
UnintentionalChaos
International Hazard
Posts: 1454
Registered: 9-12-2006
Location: Mars
Member Is Offline
Mood: Nucleophilic
|
|
Benzene comes in with an octane rating of 101 and toluene at 112. That means pure benzene is just the tiniest bit less explosively combustible than
pure iso-octane, while toluene is ever better. n-heptane, distilled from Jeffrey pine resin and sold as rubber cement thinner is 0
Woo, I am now a hazard to myself...then again, I didn't really need the little title to tell me that. On second thought, I'm probably more of a hazard
to my improvised lab equipment.
[Edited on 1-4-07 by UnintentionalChaos]
|
|
kine
Harmless
Posts: 26
Registered: 8-8-2005
Member Is Offline
Mood: No Mood
|
|
since a detonation event in the compustion chamber produce higher pressures than normal compustion, wouldn't it be possible to decrease the amount of
fuel/air entering the chamber and promoting a smaller scale of detonation wiht a fuel with no antidetonation additives, at the point that it will not
be destructive?
This will probably will not add any power output to the car but it will use much less fuel promoting beter gas mileage.
[Edited on 5-1-2007 by kine]
|
|
Boomer
Hazard to Others
Posts: 190
Registered: 11-11-2005
Member Is Offline
Mood: No Mood
|
|
Detonation does not help in combustion engines!
You want a long lasting pressure to push the piston some distance, not a shock hitting it for a fragment of a millisecond. Detonation does not produce
more energy anyway with gas/air mixes. It only does so with high explosives because they burn incompletely if they deflagrate (like NG/NC-->CO/NOx
in a gun, NG/NC-->CO2/N2 in blasting gelatine).
|
|
nitro-genes
International Hazard
Posts: 1048
Registered: 5-4-2005
Member Is Offline
|
|
Up to a certain level, the faster the deflageration is, the faster one whole cylce can be completed, resulting in higher revvings. The problem is that
combustion engines are not developed to withstand such increased pressures and rpm's. Moving parts are to heavy to handle high rmp, and to weak to
withstand the pressure of real powerfuels like NM/methanol for expample. It is basically similar to overclocking your CPU. The more juice you pump
into it, the faster it will be worn down. In streetracing there are only a small set of engines that can handle NOZ injection for longer periods of
time. And the engines of formula 1 cars are taken from cars that have run more than 100.000 km, to ensure the engine is without any weaknesses from
production, but then again they only have to run for a couple of times!
|
|