Sidmadra
Hazard to Others
Posts: 129
Registered: 17-2-2017
Member Is Offline
Mood: No Mood
|
|
Is there any feasible way to PID control a hotplate power without effecting the stirring?
Or would doing this properly require taking apart the entire hotplate and adjusting the internal wiring so the stirrer circuit isn't affected? The PWM
output of a PID to the AC power of the hotplate would interfere with the stirring I would presume. All of the digital temperature controlled hotplates
with thermocouple inputs are $300-500, right now I'm working with a $100 hotplate. If I can avoid spending some $500, it would be ideal.
|
|
|
macckone
International Hazard
Posts: 2159
Registered: 1-3-2013
Location: Over a mile high
Member Is Offline
Mood: Electrical
|
|
It would require taking the hotplate apart.
If it is bi-metal controlled then the temperature stability is probably shit as is.
If it is a PWM controlled already then it should be easy to convert.
But if it cost $100 it is probably bi-metal.
You may want to get a $15 hotplate and use overhead stirring.
|
|
|
Sidmadra
Hazard to Others
Posts: 129
Registered: 17-2-2017
Member Is Offline
Mood: No Mood
|
|
I believe it is PWM because it heats in short bursts on and off, if I'm not mistaken. I'd have to check. Could be confusing it with my other hotplate
(that broke)
|
|
|
monolithic
Hazard to Others
Posts: 435
Registered: 5-3-2018
Member Is Offline
Mood: No Mood
|
|
No, there is no simple way to do it. You need to separate the circuits for the stirring and the hot plate functions. I ran into the same issue with my
hot plate and I think I'm going to sell it and just buy a digital hotplate, because I don't want to hack up a perfectly good hot plate stirrer.
|
|
|
macckone
International Hazard
Posts: 2159
Registered: 1-3-2013
Location: Over a mile high
Member Is Offline
Mood: Electrical
|
|
sidmadra
If it is short burst it is using an integrated time proportioning controller.
It is a type of PWM but it isn't discreet enough.
If it has a hum that changes frequency when you adjust the heating dial then it is true PWM.
monolithic
If it isn't heating satisfactorily then it really isn't perfectly good.
It is the cheap controller.
|
|
|
Sigmatropic
Hazard to Others
Posts: 307
Registered: 29-1-2017
Member Is Offline
Mood: No Mood
|
|
In the old ikamag stirrer hitplate I have the stirring and heating circuits are physically separated from each other. Joined only by the transformer.
So I would say it all depends on what kind of stirrer-hotplate you've got, open it up and see.
|
|
|
Sulaiman
International Hazard
Posts: 3558
Registered: 8-2-2015
Location: 3rd rock from the sun
Member Is Offline
|
|
Yes, open it up and post photo's here.
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
