Search |
[Next Page] |
OTC dichloromethane! Found this at an Ace Hardware.
[file]101443[/file]
I first saw it on their website. The sds and l ... |
28-3-2024 at 20:43 by: Sir_Gawain |
Introduction Subscribed! |
26-3-2024 at 17:18 by: Sir_Gawain |
Suggestions on vacuum pump purchase [rquote=691726&tid=160211&author=Sulaiman]
Alternatively, low budget
https://www.youtube.c ... |
18-3-2024 at 19:08 by: Sir_Gawain |
Det Cap Strategies It’s actually a cylinder. It was cast in a regular soup can, so it’s about 7 cm in diameter. Als ... |
18-3-2024 at 18:56 by: Sir_Gawain |
Det Cap Strategies That looks great!
As I mentioned earlier, you need to get some lead blocks to test with. It gives ... |
16-3-2024 at 19:30 by: Sir_Gawain |
Bulk (4L) Solvents Available - Pickup in SoCal US For the first time in my life, I wished I lived in California. |
15-3-2024 at 11:07 by: Sir_Gawain |
Illuminating Gasampules This might not be the best for a first project, but after I finish building my 3kW spark gap coil I ... |
15-3-2024 at 08:44 by: Sir_Gawain |
Oxide layer on Copper The reason copper oxidizes so fast after being in acid is that the acid etches off a thin layer of c ... |
14-3-2024 at 18:23 by: Sir_Gawain |
Illuminating Gasampules What transistor are you using? |
14-3-2024 at 12:28 by: Sir_Gawain |
Illuminating Gasampules I think it's usually placed under the secondary, but you could try both and see which works better. |
14-3-2024 at 09:58 by: Sir_Gawain |
Illuminating Gasampules The first thing that comes to my mind is a slayer exciter powered pancake coil. It's a very simple c ... |
14-3-2024 at 09:39 by: Sir_Gawain |
NH4NO3? You can get pure ammonium nitrate by reacting it with ammonium sulfate or carbonate, then filtering ... |
13-3-2024 at 10:01 by: Sir_Gawain |
Amazon selling primary explosives I was searching for methyl ethyl ketone and found this:[url]https://www.amazon.com/Mek-Peroxide-Cata ... |
8-3-2024 at 11:54 by: Sir_Gawain |
The Short Questions Thread (4) [rquote=691381&tid=25055&author=yobbo II]
'Very informative... I try this in my newly buy r ... |
6-3-2024 at 13:09 by: Sir_Gawain |
New ETN Synthesis I’ve never had problems with ETN stability. If properly neutralized and stabilized it will last ye ... |
6-3-2024 at 08:54 by: Sir_Gawain |
Det Cap Strategies I once tested a 1g ETN detonator by drilling a hole in a chunk of lead just big enough for it to fit ... |
29-2-2024 at 08:53 by: Sir_Gawain |
Det Cap Strategies You definitely don’t want to plasticize the NHN - it would slow down the burn rate to much. It mig ... |
29-2-2024 at 06:41 by: Sir_Gawain |
Multiple bad experiences with AliExpress [rquote=691079&tid=160122&author=woelen]
At the same time, I also purchased something from ... |
26-2-2024 at 12:25 by: Sir_Gawain |
Det Cap Strategies Damage depends greatly on the hardness of the steel test plate. Also, it looks like you (LL) used st ... |
26-2-2024 at 10:11 by: Sir_Gawain |
1,4-Dioxane from Ethylene Glycol and H2SO4 I was distilling dioxane over sodium metal once and it distilled to dryness (I should have watched i ... |
26-2-2024 at 10:05 by: Sir_Gawain |
Clean burnt/melted plastic off concrete. The nitric acid is probably reacting with the concrete. If any acid gets under the plastic, it shoul ... |
20-2-2024 at 17:30 by: Sir_Gawain |
Synthesis of terephthalic acid from a PET water bottle Heating is absolutely necessary. I tried this procedure with 20 g of finely chopped pet plastic and ... |
19-2-2024 at 17:10 by: Sir_Gawain |
Cleaning the cooling jacket of a condenser I've found sodium carbonate and percarbonate to be very effective cleaners, no matter what the stain ... |
15-2-2024 at 07:19 by: Sir_Gawain |
New ETN Synthesis [rquote=690801&tid=155655&author=dettoo456]Would you choose the azeo HNO3 even over NH4NO3?
... |
9-2-2024 at 18:44 by: Sir_Gawain |
New ETN Synthesis I tried adding the erythritol to sulfuric acid, then adding nitric acid, and got a horrible yield. A ... |
9-2-2024 at 15:38 by: Sir_Gawain |
[Next Page] |