mikeyhib
Harmless
Posts: 6
Registered: 4-11-2010
Member Is Offline
Mood: No Mood
|
|
what sort of joints do I need
what sort of joints do I need to connect a reversible coil condenser( 19/26 & 24/29 ) , to a 2000 ml boiling flask with an opening of 48mm I/D.For
reflux distillation initially and then to change to normal distillation using the same condenser (collecting flask size not important)
|
|
1281371269
Hazard to Others
Posts: 312
Registered: 15-5-2009
Member Is Offline
|
|
What socket does the boiling flask have?
What are you distilling?
Do you have other jointed glassware available?
|
|
mikeyhib
Harmless
Posts: 6
Registered: 4-11-2010
Member Is Offline
Mood: No Mood
|
|
The 2000 ml boiling flask on closer inspection seems to have a 45 mm straight socket ( I thought I was buying a tapered one
at the time!) and yes i'm a beginner!
I'm distilling alchohol, and I have no other glass joints.
I believe also that I may need to make provision in my system for the addition of of glass thermometers to monitor the process.
|
|
1281371269
Hazard to Others
Posts: 312
Registered: 15-5-2009
Member Is Offline
|
|
I think the straight socket boiling flask may have to be sent back unless you can buy a special adaptor.
Jointed glassware is actually fairly straightforward. For a full setup you need a boiling flask, stillhead, condenser, thermometer adaptor, receiver
adaptor, collecting flask and possibly some expansion / reduction adaptors to boot
It's also good to know that B19 is equivalent to 19/26, B24 to 24/29 and so on.
One site that offers fairly good pricing in the UK is http://www.timstar.co.uk , so long as you go for their own brand stuff instead of the quickfit stuff.
You can also get multinecked flasks. This would allow you to connect a thermometer directly to the flask, meaning you would only need one of these
http://www.timstar.co.uk/Chemistry-/Quickfit-Jointed-Glasswa...
not one of these
http://www.timstar.co.uk/Chemistry-/Quickfit-Jointed-Glasswa...
You can also, for alcohol, save the costs of buying a thermometer adaptor and simply drill a hole in a rubber bung. But BEWARE! It's harder than it
seems and I've broken at least two thermometers trying to force them out of a bung in which they have been stuck.
Best of luck! Please U2U me if you need any more help.
|
|
entropy51
Gone, but not forgotten
Posts: 1612
Registered: 30-5-2009
Member Is Offline
Mood: Fissile
|
|
Quote: Originally posted by Mossydie | You can also, for alcohol, save the costs of buying a thermometer adaptor and simply drill a hole in a rubber bung. But BEWARE! It's harder than it
seems and I've broken at least two thermometers trying to force them out of a bung in which they have been stuck. | Use a good cork stopper and you won't have this problem. Corks work fine for non-corrosive liquids and do not swell when
exposed to organic solvents. There is an art to selecting, preparing and boring corks. One of the old lab manuals usually gives details on
the use of corks.
|
|