cnidocyte
Hazard to Others
Posts: 214
Registered: 7-7-2010
Member Is Offline
Mood: No Mood
|
|
Acid spills and polyester/cotton blend lab coats
I got at about a ml of concentrated H2SO4 on my 65% polyster/35% cotton lab coat on tuesday and when I was leaving the lab there was only a brown
stain so I thought nothing of it and stashed the lab coat in my locker. The next morning I noticed a bit acid burn on my t-shirt. Is it likely that
when I get my lab coat outta my locker next monday, there'll be a big dirty acid burn hole on it or would this polyester/cotton blend fabric have
greater acid resistance than my 100% cotton t-shirt?
|
|
blogfast25
International Hazard
Posts: 10562
Registered: 3-2-2008
Location: Neverland
Member Is Offline
Mood: No Mood
|
|
Polyester definitely resists H2SO4 better than cotton: but you'll probably find some damage on Monday.
Like most stains they're best treated early on: in the case of acid, wash with copious amounts of water immediately after the spill or ASAP...
But a lab coat isn't a lab coat without some acid burn holes: those who don't make any mistakes make nothing at all...
|
|
cnidocyte
Hazard to Others
Posts: 214
Registered: 7-7-2010
Member Is Offline
Mood: No Mood
|
|
Quote: Originally posted by blogfast25 |
But a lab coat isn't a lab coat without some acid burn holes: those who don't make any mistakes make nothing at all... |
Thats exactly the way I see it but the lab technician disagrees. Rather than blindly follow instructions from a lab book, I prefer to understand why
I'm doing what I'm doing and this requires me to make the odd mistake here and there.
|
|
psychokinetic
National Hazard
Posts: 558
Registered: 30-8-2009
Location: Nouveau Sheepelande.
Member Is Offline
Mood: Constantly missing equilibrium
|
|
I thought that was the mistake as aforementioned.
“If Edison had a needle to find in a haystack, he would proceed at once with the diligence of the bee to examine straw after straw until he found
the object of his search.
I was a sorry witness of such doings, knowing that a little theory and calculation would have saved him ninety per cent of his labor.”
-Tesla
|
|
entropy51
Gone, but not forgotten
Posts: 1612
Registered: 30-5-2009
Member Is Offline
Mood: Fissile
|
|
If you say so, but this quote implies that he does not
realize that ignoring instructions is a mistake: Quote: Originally posted by cnidocyte | Rather than blindly follow instructions from a lab book, I prefer to understand why I'm doing what I'm doing .... | He obviously didn't understand that sulfuric acid is corrosive, so I think he should stop ignoring the lab book.
[Edited on 18-11-2010 by entropy51]
|
|
cnidocyte
Hazard to Others
Posts: 214
Registered: 7-7-2010
Member Is Offline
Mood: No Mood
|
|
Quote: Originally posted by entropy51 | He obviously didn't understand that sulfuric acid is corrosive, so I think he should stop ignoring the lab book.
[Edited on 18-11-2010 by entropy51] |
Everyone on earth knows that H2SO4 is corrosive. I meant in general I prefer to learn through trial and error than blindly follow instructions from a
book. Following instructions you can replicate what you've done but you won't know what all the steps are for therefore you wont know how to modify
the methods if there is a change in variables.
|
|
blogfast25
International Hazard
Posts: 10562
Registered: 3-2-2008
Location: Neverland
Member Is Offline
Mood: No Mood
|
|
Still, don't venture too far from the book: there'll be plenty of time to get creative later... ;-) Copying is an integral part of any learning
process...
[Edited on 20-11-2010 by blogfast25]
|
|
Magpie
lab constructor
Posts: 5939
Registered: 1-11-2003
Location: USA
Member Is Offline
Mood: Chemistry: the subtle science.
|
|
By all means seek a thorough understanding of the procedural steps - but follow them - at least the first time. Then you can venture out after you
have successfully performed the procedure as written.
Many procedures, especially the older ones, are succinctly written. There's not much explanation of why things are done, but some may be vital to
safety.
The author of the procedure likely experienced some trial and error in developing the procedure. It also should have received peer review and been
proved by others prior to being published.
I will admit, however, that I have found procedures, especially from patent literature, that seem to be just garbage. But who knows, my skills aren't
perfect either.
The single most important condition for a successful synthesis is good mixing - Nicodem
|
|
12AX7
Post Harlot
Posts: 4803
Registered: 8-3-2005
Location: oscillating
Member Is Offline
Mood: informative
|
|
I have a number of shirts with thin, white or black spots, where the cotton was destroyed while the poly (white or black threads in my case, but this
depends on the shirt) threads survived.
Tim
|
|