triond
Harmless
Posts: 4
Registered: 24-3-2011
Member Is Offline
Mood: No Mood
|
|
polymere
hi
i recently viewed on wikipedia
that
the synthesis of kevlar
and i was wondering if we can make a other polymer with the same method
such that exemple
by looking this its look like nylon-66
but a sort of inefficient version lol
bye
[Edited on 25-3-2011 by triond]
|
|
matei
Hazard to Others
Posts: 205
Registered: 16-9-2006
Member Is Offline
Mood: No Mood
|
|
That would actually be Nylon 1-3.
You can make polymers by polycondensation using virtually any diamine and dicarboxylic acid chloride. The point here is to obtain a polymer with
useful properties (such as high tensile strength in case of Kevlar, etc.).
|
|
Chordate
Hazard to Others
Posts: 108
Registered: 23-2-2011
Member Is Offline
Mood: No Mood
|
|
What you are talking about making there is nylon 1,3. (polyamine naming convention is 1st number is the amine group, 2nd number is the carbonyl,
unless you are synthesizing from lactones in which case you only use 1 number). It exists. Its properties are well known. The problem is that most
nylons formed from methylenediamine are fairly strained, owing to how close the two amines are. It makes it hard to maintain larger order structure
and what you get are partially soluble, high melting semiclear goops, more similar to an epoxy than a useful polymer.
I would also suspect that that particular acid chloride is going to give you all kinds of trouble in the reaction. Those alpha hydrogens are in a
particularly electron sparse environment, and are going to be itching to find a home, and I wouldn't be surprised if the amine was strong enough to
deprotonate some. I'd also expect quite a lot of cyclization, just because of the 6 membered ring sweet spot of the diamine and the malonyl chloride.
I'd expect you'd get something out of it though. Why not try? Just remember that you're going to make a lot of foul smelling smoke and it'll be
vigorously exothermic.
|
|
triond
Harmless
Posts: 4
Registered: 24-3-2011
Member Is Offline
Mood: No Mood
|
|
so is technically possible to make a polymer made out of
oxalic acid and Ethylenediamine
?
[Edited on 25-3-2011 by triond]
|
|