Surrealist
Harmless
Posts: 5
Registered: 6-6-2018
Member Is Offline
|
|
Temperature problems
Im not sure where to post this. If I’m in the wrong section don’t hesitate to criticize
I have a bit of a practical problem on my hands-its hot outside. I don’t have the budget for a fune hood, so, for obvious safety reasons, I work on
amateur chemistry outside. 35, even 40 celcius is common to see all day in the summer. This presents some challenges: reagents like diethyl ether and
ethyl bromide boil. When a procedure calls for room temperature, I need to use a cold water bath. Adding to this that chemistry is hours of hard work
at a time-35+ celsius temperatures with safety equipment on makes for a tough hobby. Misters provide some relief, but have many drawbacks. On one
occasion, some Grignard purity 1,4 dioxane absorbed water from the humidity in the air (from the misters) and decimated my yields in said reaction.
The magnesium hydroxide precipitate made it obvious what had happened. This is really the only major blockade for me to perform more experiments.
Thank you for the help
|
|
Sulaiman
International Hazard
Posts: 3658
Registered: 8-2-2015
Location: 3rd rock from the sun
Member Is Offline
|
|
You could sleep early evening and wake early morning,
or do different experiments whilst waiting for winter
|
|
Surrealist
Harmless
Posts: 5
Registered: 6-6-2018
Member Is Offline
|
|
There are a lot of times where I have to work in those conditions simply due to a busy schedule. What is your advice on things like less heat-trapping
safety equipment? Maybe shorter sleeves and a disposable labcoat?I think that would be my best bet on my budget.
|
|
WGTR
National Hazard
Posts: 971
Registered: 29-9-2013
Location: Online
Member Is Offline
Mood: Outline
|
|
A cooling vest similar to this might help: https://www.glaciertek.com/, but it's just an idea. It looks like several companies make them, or you can make one yourself if you're handy.
Alternately, maybe you could get a small window unit and cordon off a work space with plastic sheeting or something, just as a temporary measure.
I once worked on an engine when it was about 50 degrees in the garage. Most of my time was spent in front of a very big fan, spraying myself down
with water. I could put down the water bottle and work for about 30 seconds, then all the water would evaporate and I'd have to pick up the spray
bottle again. That was a very slow and miserable day.
|
|