chemkid
Hazard to Others
Posts: 269
Registered: 5-4-2007
Location: Suburban Hell
Member Is Offline
Mood: polarized
|
|
Aluminium and HCl gray insoluble precipitant
I reacted aluminium foil with muriatic acid until no more aluminium would react. The reaction formed a gray foam of bubbles. I left the beaker out
overnight with a watch glass over it to allow any remaining aluminium flakes to react. In the morning i found there was still a gray precipitant. It
measured a very low pH (cabbage indicator solution and pH paper). The precipitant did not dissolve with water or HCl. The precipitant seemed to float
on the solution but i am not sure of that. Filtration yielded a gray filtrate.
To the best of my knowledge aluminium chloride is yellow and soluble in water. I don't think it was aluminium because that would have reacted upon the
addition of more acid. Perhaps an impurity in the metal. Any insight on what the precipitant may be and if this is normal would be appreciated.
Furthermore , why does the reaction of aluminium and HCl turn gray?
Chemkid
|
|
12AX7
Post Harlot
Posts: 4803
Registered: 8-3-2005
Location: oscillating
Member Is Offline
Mood: informative
|
|
Could be silicon and other impurities.
Tim
|
|
Polverone
Now celebrating 21 years of madness
Posts: 3186
Registered: 19-5-2002
Location: The Sunny Pacific Northwest
Member Is Offline
Mood: Waiting for spring
|
|
If you still think this is a mystery, consider continuing discussion in the mystery reaction thread.
PGP Key and corresponding e-mail address
|
|