Sciencemadness Discussion Board
Not logged in [Login ]
Go To Bottom

Search
[Next Page]
Building an Analytical System for Plant Alkaloids
Thanks for the suggestion. I will look for that. I recently happened to scour a few Goodwill stores ...
25-7-2024 at 04:20
by: Jenks
Building an Analytical System for Plant Alkaloids
I've made a little progress in the last four days.

The Arduino IDE was installed on the Ubuntu 24 ...
24-7-2024 at 08:53
by: Jenks
Building an Analytical System for Plant Alkaloids
[rquote=694257&tid=160406&author=bnull]It was an idea. :([/rquote]
It was a good idea, and ...
20-7-2024 at 12:09
by: Jenks
Building an Analytical System for Plant Alkaloids
Thanks for the reply, bnull. Both quartz cuvettes have 1mm thick walls but the glass ones are 1.25mm ...
19-7-2024 at 02:15
by: Jenks
Building an Analytical System for Plant Alkaloids
I tried cutting the ends off three of the four glass cuvettes with a carbide disk on a Dremel:

[f ...
18-7-2024 at 09:34
by: Jenks
Building an Analytical System for Plant Alkaloids
I got around to testing the cuvettes and the flow cell that I bought for this project. What I purcha ...
18-7-2024 at 06:12
by: Jenks
Building an Analytical System for Plant Alkaloids
So far I have successfully connected the Raspberry Pi A I brought to my Ubuntu laptop through an eth ...
17-7-2024 at 18:59
by: Jenks
Building an Analytical System for Plant Alkaloids
A little update - I have arrived Safely in Ghana with myself and my copious supplies intact. Another ...
13-7-2024 at 09:48
by: Jenks
Building an Analytical System for Plant Alkaloids
Thank you, Anthracene, for your feedback and encouragement - it goes a long way. I bought two rather ...
4-7-2024 at 22:18
by: Jenks
Extracting the alkaloid scopolamine from datura stramonium seeds?
There is a lot of wisdom in this thread. Beyond the physical and psychological hazards of being deli ...
4-7-2024 at 09:53
by: Jenks
Building an Analytical System for Plant Alkaloids
Thanks for the article suggestion - it does look relevant, and it is even accessible! I will check i ...
3-7-2024 at 21:26
by: Jenks
OTC dichloromethane!
[rquote=693933&tid=160257&author=squeezix]Weld-on #4
And an even higher concentration in we ...
2-7-2024 at 16:18
by: Jenks
Building an Analytical System for Plant Alkaloids
I am starting a project in a few weeks that has been on my mind for most of my adult life - there ne ...
30-6-2024 at 07:36
by: Jenks
Building a DIY Pirani Gauge from a lightbulb
This is a nice experiment and I will remember it. I wonder if silicone might work better than epoxy ...
28-6-2024 at 15:35
by: Jenks
IKA HS7 - no temp control or actuator response
I'm amazed it made it ten minutes if it wasn't designed for 220v.
22-6-2024 at 13:29
by: Jenks
Ika cmag hs7 fried circuit
Or check the fuses with a multimeter first.
22-6-2024 at 13:26
by: Jenks
aquarium/hydroponic chiller
I thought I remembered an alternative that is designed for lab use, but this one apparently requires ...
20-6-2024 at 11:30
by: Jenks
Trifluoroacetic anhydride?
Unless the point here is the challenge, I think if I were needing this, it would seem like the perfe ...
4-6-2024 at 05:02
by: Jenks
Diethylether (sulfuric acid saving method)
[rquote=693134&tid=160329&author=Keras][rquote=693133&tid=160329&author=Jenks]Phosph ...
19-5-2024 at 18:51
by: Jenks
Diethylether (sulfuric acid saving method)
Phosphoric acid seems to be the obvious alternative to prevent reduction of the acid from being a pr ...
19-5-2024 at 11:26
by: Jenks
High temperature stir bar.
Maybe a paper clip coated in silicone? Or boiling stones or capillary sealed at the top.
16-4-2024 at 09:18
by: Jenks
High temperature stir bar.
[rquote=692504&tid=160288&author=Chemgineer]
Could maybe try and find a piece of steel enca ...
15-4-2024 at 16:13
by: Jenks
High temperature stir bar.
That is the maximum temperature of the surface of the hot plate. The contents of a container on UT w ...
12-4-2024 at 06:39
by: Jenks
Bromazolam ranging melting points
Probably not. I don't know what the two products is referring to, but in general, the less pure so ...
17-3-2024 at 18:12
by: Jenks
DCM storage
The original post was about DCM that disappeared from a plastic bottle. I too received DCM in a plas ...
12-2-2024 at 19:40
by: Jenks
[Next Page]

  Go To Top