anticoplanar
Harmless
Posts: 13
Registered: 16-3-2007
Member Is Offline
Mood: No Mood
|
|
saponification w/ water hydrolysis
What conditions would be needed to create soap without the use of sodium hydroxide? Any ideas as to the pressure/temperature?
Thanks
|
|
Nicodem
Super Moderator
Posts: 4230
Registered: 28-12-2004
Member Is Offline
Mood: No Mood
|
|
Soap is sodium or potassium salts of fatty acids, so what other source of sodium or potassium cations do you propose? This is most important to
specify since the speed of the hydrolysis is very, very dependant on the nature of the counterion.
|
|
Klute
International Hazard
Posts: 1378
Registered: 18-10-2006
Location: France
Member Is Offline
Mood: No Mood
|
|
Wouldn't K,Na+ carbonates manadge to saponify triglycerides? Less effective than hydroxides, but with longer reaction time and higher temperatures, it
could give a decent yield, no?
|
|
Nicodem
Super Moderator
Posts: 4230
Registered: 28-12-2004
Member Is Offline
Mood: No Mood
|
|
Yes, at 140-150°C they should perform more or less equally good as hydroxydes at 100°C.
|
|
not_important
International Hazard
Posts: 3873
Registered: 21-7-2006
Member Is Offline
Mood: No Mood
|
|
Just boiling an alkali carbonate solution with fats will result in hydrolysis of the fats and formation of soap. The carbonate itself undergoes a
small amount of hydrolysis, so there is a bit of hydroxide and 'H2CO3' in the solution. Boiling drives out the CO2, greatly aided by the escaping
steam. Takes some time, slower than starting with hydroxide, but it does go.
|
|