smeesh
Harmless
Posts: 17
Registered: 7-3-2012
Member Is Offline
Mood: No Mood
|
|
liquid oxygen evaporation
hello there guys.
i had a question concerning liquid oxygen in a pressure vessel.
lets say, i dont use the "proper" vessel. lets say i use a good old fashioned gas cylinder that will allow the liquid oxygen to be heated by
surrounding air that is coming into contact with the walls of the container. if i had filled the container to the brim and then i let this happen, is
an explosion likely?
ive been going over it in my head and it seems quite possible. the change from liquid to gas could perhaps increase the pressure just like an
old-timey steam boiler...right?
i could use some info. thank ya sirs
|
|
|
watson.fawkes
International Hazard
Posts: 2793
Registered: 16-8-2008
Member Is Offline
Mood: No Mood
|
|
What's the vapor pressure of O2 at 40 °C?
|
|
|
neptunium
National Hazard
Posts: 986
Registered: 12-12-2011
Location: between Uranium and Plutonium
Member Is Offline
|
|
oxygen, like a few other, gas were thought to be permanent gas. meaning during the mid 1800's ( the thermodynamic age),these gases could not be
liquified by preassure alone.
O2 has a critical point above witch it will not be condensed into a liquide. water's critical temperature is arround 374C.
O2 critical point is at -118C, well below zero.
so unless you fill a steel cylinder with liquid ox and keep it below this temperature, your tank will explode.
|
|
|
franklyn
International Hazard
Posts: 3026
Registered: 30-5-2006
Location: Da Big Apple
Member Is Offline
Mood: No Mood
|
|
Liquid oxygen is kept in a dewer at atmospheric pressure , and slowly evaporates away.
Without refrigeration ordinary gas cylinders cannot hold up to the pressure of so much weight
of oxygen as would be initially present in the liquid state , without a valve to bleed the excess
pressure that would accumulate as it becomes a supercritical (gas / fluid) when it heats up to
room temperature. Something around 25000 pounds per square inch. What amounts to the
isothermal compression of oxygen gas in the ratio of 860 to one at room temperature.
http://community.discovery.com/eve/forums/a/tpc/f/7501919888...
http://navyaviation.tpub.com/14019/css/14019_15.htm
http://tinyurl.com/7fo5eb6
Phase diagrams are your friend
http://www.chemguide.co.uk/physical/phaseeqia/phasediags.htm...
Critical Temperature : Temperature above which liquid cannot exist at any pressure
Critical temperature of oxygen, -181.43 °F, (154.6 Kelvin)
Critical pressure : of oxygen (minimal pressure necessary at the critical temperature)
731.4 pounds per square inch absolute (psia)
or 50.43 bar (atmospheres)
or 5043 kiloPascals
Here is a demonstration of liquid chlorine undergoing transition from liquid to supercritical fluid
http://www.youtube.com/watch?v=Y6S7bZbx4-s
The meniscus slowly vanishes , then as it cools off to the lower transition temperature the
meniscus again appears signifying separate gas and liquid phases are again present.
Design Guide for High Pressure Oxygen Systems NASA RP 1113, 1983.
http://ntrs.nasa.gov/archive/nasa/casi.ntrs.nasa.gov/1983002...
Cryogenic Solid Oxygen Storage & Sublimation Investigation
http://www.dtic.mil/dtic/tr/fulltext/u2/687852.pdf
P.S.
are you designing a nefarious device ?
.
|
|
|
Ral123
National Hazard
Posts: 735
Registered: 31-12-2011
Member Is Offline
Mood: No Mood
|
|
So what are these big cylinders that welders use full of? So if they are filled with oxygen, some of it in liquid phase, the pressure is like 2000
atmospheres? And is the same with nitrogen?
|
|
|
franklyn
International Hazard
Posts: 3026
Registered: 30-5-2006
Location: Da Big Apple
Member Is Offline
Mood: No Mood
|
|
@ Ral123
So what are these big cylinders that welders use full of ?
They're full of whatever they are filled with. Otherwise
they are just full of air space. Note * Acetylene cylinders
are filled with porous rock and acetone , the solvent in
which the acetylene content is dissolved. This is done to
obviate detonation resulting from runaway polymerization .
So if they are filled with oxygen, some of it in liquid phase,
the pressure is like 2000 atmospheres ?
No.
If there is liquid phase present , it is because the bottle and
the contents are below the critcal temperature. The critical
pressure to maintain it liquid is just about 50 atmospheres.
To have oxygen contained at 2000 atmospheres, it will be
hotter than the critical temperature by some amount , and
determined by the weight of oxygen in the volume of the
cylinder. This is readily figured by the combined gas law
formula
P V = n R T , solving for the pressure P = nRT / V
P = Pressure
n = number of mols ( total weight of content divided by
. . . gram molecular weight of oxygen)
R = constant .0821 ( it is the same for all common gases)
T = ambient temperature ºC + 273.15
V = volume of cylinder
A minor point , the assumption is that only oxygen is present
inside the cylinder. One can have liquid oxygen at 2000 atm.
by having the unfilled space above the lquid phase filled with
some other gas having a much lower critical temperature ,
usually somthing like helium.
And is the same with nitrogen ?
It is also one of the so called permanent gases , so yes.
.
|
|
|
Ral123
National Hazard
Posts: 735
Registered: 31-12-2011
Member Is Offline
Mood: No Mood
|
|
Forgive me for being so dump, but I don't understand a thing. If I wana have oxygen at near "1.141 kg/L" in my room with no cooling stuff, whatsoever,
how may bars is that? For example if I'm out of ammonium nitrate and want to blow sh*t up and have only and old compressor. What pressure do I need to
liquefie air?
|
|
|
unionised
International Hazard
Posts: 5105
Registered: 1-11-2003
Location: UK
Member Is Offline
Mood: No Mood
|
|
Quote: Originally posted by Ral123  | | Forgive me for being so dump, but I don't understand a thing. If I wana have oxygen at near "1.141 kg/L" in my room with no cooling stuff, whatsoever,
how may bars is that? For example if I'm out of ammonium nitrate and want to blow sh*t up and have only and old compressor. What pressure do I need to
liquefie air? |
You can't.
as has been pointed out.
Critical Temperature : Temperature above which liquid cannot exist at any pressure
Critical temperature of oxygen, -181.43 °F, (154.6 Kelvin)
|
|
|
bquirky
Hazard to Others
Posts: 316
Registered: 22-10-2008
Location: Perth Western Australia
Member Is Offline
Mood: No Mood
|
|
I think welders oxygen is actually just compressed oxygen it is still in the gas state
|
|
|
watson.fawkes
International Hazard
Posts: 2793
Registered: 16-8-2008
Member Is Offline
Mood: No Mood
|
|
| Quote: Originally posted by Ral123 | | So what are these big cylinders that welders use full of? So if they are filled with oxygen, some of it in liquid phase, the pressure is like 2000
atmospheres? And is the same with nitrogen? |
Let me guess. After three response all having to do with phase
diagrams, did you go look up the phase diagram of oxygen? It doesn't seem so.
My question was a trick one, because, as others have pointed out, at room temperature it's far above the critical point, and so "vapor pressure" isn't
a well-defined term. You would have understood a lot to have figured that out for yourself.
Instead, go do some reading and come back with better questions.
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
