Sciencemadness Discussion Board
Not logged in [Login ]
Go To Bottom

Printable Version  
Author: Subject: How long to heat NaHCO3 to make Na2CO3
KonkreteRocketry
Hazard to Others
***




Posts: 165
Registered: 12-11-2012
Location: Dubai
Member Is Offline

Mood: No Mood

[*] posted on 10-3-2013 at 06:13
How long to heat NaHCO3 to make Na2CO3


How long does it take for a 200 degree hot plat to transform around 50 grams of NaHCO3 to Na2CO3 ?
View user's profile View All Posts By User
Prometheus23
Hazard to Self
**




Posts: 62
Registered: 6-6-2012
Member Is Offline

Mood: No Mood

[*] posted on 10-3-2013 at 06:45


As NaHCO3 decomposes into Na2CO3 it gives of water and carbon dioxide. You'll see puffs of gas start to be released from the powder and as the temperature rises the gas will be given off faster and faster. Eventually the production of CO2 will slow down and then eventually stop. After this happens just continue heating the sample for a little while longer to ensure it goes to completion. So you'll be able to tell when the conversion is essentially complete.
View user's profile View All Posts By User
hissingnoise
International Hazard
*****




Posts: 3940
Registered: 26-12-2002
Member Is Offline

Mood: Pulverulescent!

[*] posted on 10-3-2013 at 07:21


Or, you could just buy washing soda OTC?
View user's profile View All Posts By User
Hexavalent
International Hazard
*****




Posts: 1564
Registered: 29-12-2011
Location: Wales, UK
Member Is Offline

Mood: Pericyclic

[*] posted on 10-3-2013 at 09:01


Yes, but the purity of this is not always guaranteed: the washing soda here in the UK is labeled as "30%+ sodium carbonate", and, when I dissolved some in water, the mixture was cloudy, necessitating recrystallization for lab work.



"Success is going from failure to failure without loss of enthusiasm." Winston Churchill
View user's profile View All Posts By User
vmelkon
National Hazard
****




Posts: 669
Registered: 25-11-2011
Location: Canada
Member Is Offline

Mood: autoerotic asphyxiation

[*] posted on 10-3-2013 at 16:15


I would say somewhere between 30 min to 1 hour.
I have measured the mass before and after and it works out.
I was doing this in a fireplace and once, the fire was too hot and it melted the Na2CO3 :).
View user's profile View All Posts By User
Steve_hi
Hazard to Others
***




Posts: 196
Registered: 4-12-2010
Member Is Offline

Mood: No Mood

[*] posted on 12-3-2013 at 14:12


You could by quite cheaply sodium carbonate in the swimming pool supplies
View user's profile View All Posts By User
metalresearcher
National Hazard
****




Posts: 731
Registered: 7-9-2010
Member Is Offline

Mood: Reactive

[*] posted on 13-3-2013 at 04:56


Each supermarket sells soda ash which is actually virtually pure Na2CO3.10H20.
If you want to get rid of the crystal water, just heat it to a few 100 degrees on a hotplate or stove.
View user's profile View All Posts By User
vmelkon
National Hazard
****




Posts: 669
Registered: 25-11-2011
Location: Canada
Member Is Offline

Mood: autoerotic asphyxiation

[*] posted on 14-3-2013 at 18:32


Quote: Originally posted by metalresearcher  
Each supermarket sells soda ash which is actually virtually pure Na2CO3.10H20.
If you want to get rid of the crystal water, just heat it to a few 100 degrees on a hotplate or stove.


Not in Canada.
On the other hand, hardware stores and department stores that sell pool supplies sell it as a pH increaser.
View user's profile View All Posts By User
elementcollector1
International Hazard
*****




Posts: 2684
Registered: 28-12-2011
Location: The Known Universe
Member Is Offline

Mood: Molten

[*] posted on 14-3-2013 at 18:34


Not in Washington either, at any rate. No 'washing soda' here, just Tide. JUST. TIDE.



Elements Collected:52/87
Latest Acquired: Cl
Next in Line: Nd
View user's profile View All Posts By User

  Go To Top