andy
Harmless
Posts: 23
Registered: 15-11-2013
Member Is Offline
Mood: No Mood
|
|
Hydrogenated of mesityl oxide with acetic acid
Hi
Can mesityl oxide be hydrogenated with glacial acetic acid, or other acid and maybe some other chemicals?
I don't want to use hydrogen and Pd catalyst.
Thanks
|
|
|
Nicodem
|
Thread Moved
17-11-2013 at 00:22 |
Random
International Hazard
Posts: 1018
Registered: 7-5-2010
Location: In ur closet
Member Is Offline
Mood: Energetic
|
|
There is no way this could happen with only acid, maybe fe/hcl or something similar like zn/acoh. But these are very drastic reductions, often
resulting in alkanes when starting from ketones. Which product do you want to obtain?
|
|
|
andy
Harmless
Posts: 23
Registered: 15-11-2013
Member Is Offline
Mood: No Mood
|
|
Methyl isobutyl ketone , would isopropanol or Formic acid work?
|
|
|
plante1999
International Hazard
Posts: 1936
Registered: 27-12-2010
Member Is Offline
Mood: Mad as a hatter
|
|
You seriously need to learn chemistry, it is not because something can be oxidized that it will reduce chemical. Go learn a bit, tip:
Ammonium formate + Pd Cat
HgCl2 + Al
I never asked for this.
|
|
|
deltaH
Dangerous source of unreferenced speculation
Posts: 1663
Registered: 30-9-2013
Location: South Africa
Member Is Offline
Mood: Heavily protonated
|
|
plante1999, would the use of Al in this case not result in poor selectivity by way of reduction of the carbonyl? Also, did you not
mean HgCl2 + Al + iPrOH? I have no experience with Al reduction like this, so just curious.
[Edited on 17-11-2013 by deltaH]
|
|
|
Random
International Hazard
Posts: 1018
Registered: 7-5-2010
Location: In ur closet
Member Is Offline
Mood: Energetic
|
|
Al isopropoxide may work but I am not sure, it is more mild stuff
Still would reduce ketone to alcohol iirc, not sure about double bond
HgCl2 and Al will probably reduce to alkane like metal acid reduction
You need to reduce double bond while leaving ketone group intact which would mean hydrogenation with hydrogen and pd/c probably
[Edited on 17-11-2013 by Random]
|
|
|
plante1999
International Hazard
Posts: 1936
Registered: 27-12-2010
Member Is Offline
Mood: Mad as a hatter
|
|
Poor selectivity, probably, although it would at least give some yield. I read about isopropoxide reduction, but I doubt it apply in this situation.
I never asked for this.
|
|
|
Random
International Hazard
Posts: 1018
Registered: 7-5-2010
Location: In ur closet
Member Is Offline
Mood: Energetic
|
|
Considering double bond reduction proved to be sucessful only with Pd/C in rheosmin and zingerone threads everything else would be not selective. If
this may work then zingerone could be made from unsaturated ketone from isopropoxide.
|
|
|
deltaH
Dangerous source of unreferenced speculation
Posts: 1663
Registered: 30-9-2013
Location: South Africa
Member Is Offline
Mood: Heavily protonated
|
|
Hold on, I'm still confused here...
| Quote: | | HgCl2 and Al will probably reduce to alkane like metal acid reduction |
Where does the hydrogen come from?
The reason I added the iPrOH is because I assumed you still needed a hydrogen donor?
andy, why are you keen to avoid Pd/C, I think any other way is bound to be (a)harder, (b)more expensive, (c) lower yielding and (d) a
bigger headache 
Remember, you can recover your Pd/C by filtration.
Is your worry that you don't want to hassle with H2 gas supply? That might be solvable by using formic acid as a hydrogen source with Pd/C as
mentioned. Also, you can construct a simple water electrolysis cell to supply you hydrogen that can bubbled directly to your hydrogenation setup. That
way you can generate large amounts of hydrogen as a steady stream for long periods of time and it would be cheap... well minus an initial investment
into decent electrodes.
[Edited on 17-11-2013 by deltaH]
|
|
|
andy
Harmless
Posts: 23
Registered: 15-11-2013
Member Is Offline
Mood: No Mood
|
|
deltaH
It was just the cost of Pd, thought there might be a cheap way  , and would have
gone down the electrolysis route, have got some carbon/Ti electrodes
Adding NaOH to acetone makes red diacetone, adding acetic acid and water turned it yellow, I'm guessing mesityl oxide , is this formula correct
CH3C(O)CH2C(OH)(CH3)2 + 3 CH3CO2H + -4 H2O = 4 CH3C(O)CH
[Edited on 17-11-2013 by andy]
|
|
|
deltaH
Dangerous source of unreferenced speculation
Posts: 1663
Registered: 30-9-2013
Location: South Africa
Member Is Offline
Mood: Heavily protonated
|
|
If you find that carbon anodes have insufficient durability for your water electrolysis needs, consider using IrO2/Ti anodes. It is my understanding
that these are favoured for water electrolysis.
|
|
|
andy
Harmless
Posts: 23
Registered: 15-11-2013
Member Is Offline
Mood: No Mood
|
|
Trying to get my head around the experiments, does this formula make sense?
CH3C(O)CH + H2O + NaOH = CH3OH + CH3COONa
Mesityl oxide + Water + Sodium hydroxide = Methanol + Sodium acetate
Thanks
|
|
|
Random
International Hazard
Posts: 1018
Registered: 7-5-2010
Location: In ur closet
Member Is Offline
Mood: Energetic
|
|
DeltaH hydrogen would come from the water as Al would be dissolving.
Andy, your last post makes no sense. No way this could be done.
|
|
|
andy
Harmless
Posts: 23
Registered: 15-11-2013
Member Is Offline
Mood: No Mood
|
|
When I mix NaOH or ethanol with the mixture crystal form or a white gel, could it be sodium propionate and Ethyl propionate?
|
|
|
Random
International Hazard
Posts: 1018
Registered: 7-5-2010
Location: In ur closet
Member Is Offline
Mood: Energetic
|
|
No way... You barely know anything about organic chemistry. Please read up on some reaction mechanisms and function groups. Wikipedia will be a good
read here.
|
|
|
![[*]](images/xpblue/default_icon.gif){kind=icon}
